Motion Commands
This section of commands is probably the most complex compared to the all other segments in a part program. These will be able to move the tool across the geometry statements that were defined earlier.
Motion Vocabulary
UTOPS : Automatic part surface
AVOID : Avoid the specified points in drilling operation
CALL : Call a macro
CBORE : Counter bore cycle (G82)
CNSINK : Counter sink cycle (G82)
CONST : Constant as used for numbering sequence in pattern drilling
CSINK : Counter sink cycle (G82)
CUT : Cut means the generated tool points are transferred to CLDATA
CUTTER : Cutter type specifications
CYCLE : Canned cycle for drilling
DEEPHL : Deep hole drilling cycle
DNTCUT : Don’t cut means the generated tool points are not transferred to CLDATA
DRILL : Drilling canned cycle
FACE : Face milling
FACEML : Face milling
FROM : From to specify the start point for the cutter
GO : To specify the point of contact between the tool and the work surface
GOBACK : Action verb go back
GODLTA : To move the tool in relative coordinates
GODOWN : Action verb go down
GOFWD : Action verb go forward
GOLFT : Action verb go left
GORGT : Action verb go right
GOTO : To control the flow of program
GOUP : Action verb go up
IF : If as a means providing a decision point in a program
INDIRP : In the direction of a point
INDIRV : In the direction of a vector
INTOL : Inside tolerance
INVERS : To specify the numbering sequence in reverse order
JUMPTO : To control the flow of program
MACRO : Macro definition
NOMORE : Transformation matrix is cancelled
NOPS : No part surface
OMIT : Omit the specified points
ON : Tool position with reference to drive surface
OUTTOL : Out side tolerance
PSIS : Part surface is
PSTAN : Tangent to part surface
TERMAC : Terminate macro
THRU : All the points through
TLAXIS : Tool axis
TLLFT : Tool left of drive surface
TLON : Tool on the drive surface
TLRGT : Tool right of drive surface
TO : Tool position with reference to drive surface
TOLER : Tolerance specification
TRACUT : Transpose the cutter location data