Write the differences between reaction and impulse turbine, Mechanical Engineering

Assignment Help:

(a) Show that the force exerted by a jet of water on an inclined fixed plate in the dissection of jet is given by fx = .a.v² . sin²θ. Where a is area of jet, v is velocity of jet and θ is inclination of plate with jet.

(b) Write the differences between Reaction and impulse turbine.

Related Discussions:- Write the differences between reaction and impulse turbine

Strength of materials, simply supported beam subjected to point loads resul...

simply supported beam subjected to point loads results

Determine the fluctuation in rail pressure under one wheel, An inside cylin...

An inside cylinder locomotive has its cylinder centre lines 0.70m apart and has a stroke of 0.60m. Rotating mass per cylinder = 150kg Distance between wheel Centre lines = 1.

Transmission of power, slip of belt

slip of belt

Design the helical compression spring, A helical compression spring prepare...

A helical compression spring prepared of oil tempered carbon steel, is subjected to a load which goes from 600 N to 1600 N. The spring index is 6 and the design factor of safety is

Copper alloys, Copper Alloys Some alloys of copper are employed in ind...

Copper Alloys Some alloys of copper are employed in industry for varying causes. Copper forms alloys along with zinc or the brasses, tin or the bronzes, along with tin and pho

Method of section, Figure shows a Warren girder consisting of seven members...

Figure shows a Warren girder consisting of seven members each of 3 m length freely supported at its end points. The girder is loaded at B and C as given. Determine the forces in al

Calculate composition and microstructure, It is desired to produce an iron-...

It is desired to produce an iron-carbon alloy that has a minimum hardness of 200 HB and a minimum ductility of 35%RA. Is such an alloy possible? If so, what will be its composition

Vibration damping and size-factors in clutch design , Vibration Damping : ...

Vibration Damping : Suitable mechanism should be incorporated within the clutch to eliminate (to reduce it drastically) noise produced in the transmission. Size : The size of

Describe that energy is a point function, (a) Describe that Energy is a poi...

(a) Describe that Energy is a point function and a property of the system. (b) What is the essence of 1 st law of thermodynamics ? Write down expression for the first law appli

Compute the outside diameter of the shaft, Compute the outside diameter of ...

Compute the outside diameter of the shaft: A hollow shaft of diameter ratio is 0.4 is needed to transit 600 kW at 120 rpm. The maximum torque being 20% greater than the mean t

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages