Why do we use xra a instruction, Electrical Engineering

Assignment Help:

Why do we use XRA A instruction

The XRA A instruction is used to clear the contents of the Accumulator and keep the value 00H.

 


Related Discussions:- Why do we use xra a instruction

Working principle of an electronic voltmeter, Q.   Explain the working prin...

Q.   Explain the working principle of an electronic voltmeter. Sol. Electronic voltmeter Basic Voltmeter: The addition of a series resistor, or multiplier, converts the

Determine collector - emitter voltage and base current, Q. A transistor is ...

Q. A transistor is connected in common emitter configuration collector supply voltage Vcc is 10 volts load resistance Rl is 800ohm,voltage drop across load resistance is 0.8v and c

Operation of a biased clipper and combination clipper, Q What is a clipper?...

Q What is a clipper? Describe the operation of a biased clipper and combination clipper. The circuit with which the waveform is shaped by removing (or clipping) a portion of th

Voltage tripler and quadrupler, Voltage Tripler and Quadrupler: Voltag...

Voltage Tripler and Quadrupler: Voltage Tripler an extension of the half wave voltage across each diode is 2Vm as it is for the filter capacitor circuit. It should be obvious

Registers - microprocessors architecture , Registers Various  register...

Registers Various  registers  shown in figure  are discussed  below  in detail.

Sketch the inductor voltage and stored energy, (a) Consider a 5-µH inductor...

(a) Consider a 5-µH inductor to which a current source i(t) is attached, as shown in Figure (b). Sketch the inductor voltage and stored energy as a function of time. (b) Let a v

Measurement, explain a basic measurement system

explain a basic measurement system

Student, difference between cmp and sub in microprocessor.

difference between cmp and sub in microprocessor.

Analog averaging system, Consider the analog averager where x(t) is the inp...

Consider the analog averager where x(t) is the input and y(t) is the output. (a)   Find the impulse response h(t) of the average.  Is this system causal? (b)   Let x(t)

Why memory decoding is required, Why memory decoding is required? To a...

Why memory decoding is required? To attach a memory device to the microprocessor, this is necessary to decode the address sent by the microprocessor. Decoding creates the memo

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd