Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Q . Why CE Configuration is widely used in amplifier circuit?
The main utility of a transistor lies in its ability to amplify weak signals. The transistor alone cannot perform this function. We have to connect some passive components & a biasing battery. Such a circuit is then called an amplifier. In most of the applications we use a no: of amplifier stages. Such a connection of amplifier stages is known as cascaded amplifier. In such an amplifier,input resistance of the first stage acts as the load resistance to the source. The performance of the first stage is not disturbed when second stage is connected. For this output resistance of the first stage should be low & input resistance of second stage should be high. A good amplifier stage is one which has high input resistance & low output resistance. A transistor in CB configuration has a very low input resistance & very high output resistance. It is the reverse of what we desire. That is why CB configuration is unpopular . Input resistance of CC configuration is very high & output resistance is quite low. But the voltage gain of the CC amplifier is very low. Comparatively, the CE configuration is much better as regards its input& output resistances. Its input resistance is about 1 k? & output resistance is about 10 k? A transistor in the CE configuration makes a much better amplifier. The current gain,voltage gain 7 power gain of CE is much better than those of CB.
WHOLE COIL WINDING
AC Operation of an iron core Hence, if a wattmeter were used to measure the power delivered over a full period of the waveform (which will also b
For a 45-kVA, three-phase, wye-connected, 220- V synchronous machine at rated armature current, the short-circuit load loss (total for three phases) is 1.80 kWat a temperature of 2
Solution for dc motor speed and position controller
explain why entropy of a gas increases with volume and tempearture
A 10-hp, 230-V, 500-r/min shunt motor, having a full-load armature current of 37 A, is started with a four-point starter. The resistance of the armature circuit, including the inte
Determine the magnetic flux: A coil is wound uniformly with 300 turns over a steel ring of relative permeability 900, with a mean circumference of 40mm and cross-sectional are
A 3 phase 400 volt(line to line) wye connected synchronous motor has Xs= 1 ohm per phase and a negligible armature resistance. The field current is so adjusted that the internal(in
There is a requirement to propose a new ASIC design flow within your company, from VHDL design capture through to GDSII tape out. It is very important that the flow includes all t
1. Modeling of Armature and Field Controlled DC motors: Steady state and dynamic models; development of block diagrams; assumptions used; complexity involved in realistic models;
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd