Which steps are used at receiver end by check sum, Computer Networking

Assignment Help:

Q. Which steps are used at receiver end by check sum?

The receiver follows these steps:

  • The unit is divided into "k" sections each of "n" bits
  • All sections are added utilizing one's complement to get the sum.
  • The sum is complemented.
  • If the product is zero the data are accepted otherwise rejected

1371_Which steps are used at receiver end by check sum1.png

Check Sum-An Example


Related Discussions:- Which steps are used at receiver end by check sum

Explain the hubs and repeaters, Hubs/Repeaters Hubs/Repeaters are used ...

Hubs/Repeaters Hubs/Repeaters are used to connect together two or more network segments of any media type. In larger design, signal quality starts to deteriorate as segment exc

Features of transmission control protocol, The major features of TCP are fo...

The major features of TCP are following: Reliability : TCP ensures that any data sent by a sender arrives at the destination as it was sent. There cannot be any data loss or mo

Unused reserved - trannsport layer, Unused Reserved This  is a 6 bi...

Unused Reserved This  is a 6 bite field  reserved for future use.

List some most useful advantages of token ring, List some most useful advan...

List some most useful advantages of Token Ring. Here are Token ring's most useful advantages: a. It depends excellent throughput under high-load conditions. b. Token Ring

operational amplifier and peak detector circuit, Question The operatio...

Question The operational amplifier in the peak detector circuit shown in the figure below is powered from plus and minus 15 V. If Vout is at 1V and Vin is at 0.5V, at approxima

#incident response scenario, assignment is for incident response In this ...

assignment is for incident response In this final week, you will provide a short procedures document (2–3 pages) concerning the steps by which to prepare for and execute expert te

Distinguish between physical topology and logical topology, Question: (...

Question: (a) (i) Distinguish between Physical topology and Logical topology. (ii) Explain the following statement with the help of a diagram: "A star topology can have a l

Cnet sliding window protocol, implementing cnet sliding window protocol wit...

implementing cnet sliding window protocol with 6 nodes

Global positioning system (gps) tracking, By utilizing measurements of the ...

By utilizing measurements of the so-called pseudo range between an object and each of several earth orbiting GPS satellites, the object can be very accurately located in space. A g

Maximum packet lifetime, Take the maximum packet lifetime, T.  It's stated ...

Take the maximum packet lifetime, T.  It's stated that T must be big enough to make sure the packet and its ACK have vanished.  Why do we have to have the ACK?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd