What is the use of ale, Electrical Engineering

Assignment Help:

What is the use of ALE

The ALE is used to latch the lower order address so that it can be available in T2 and T3 and used for identify the memory address. During T1 the ALE goes high, the latch is transparent ie, the output changes according to the input data, so the output of the latch is the lower order address. When ALE goes low the lower order address is latched unless the next ALE

 


Related Discussions:- What is the use of ale

Digital, #quesFind a minimum two level, multiple-output AND-OR gate circuit...

#quesFind a minimum two level, multiple-output AND-OR gate circuit to realize these functions (eight gates minimum). F1(a,b,c,d) =Sm(10,11,12,15) +D (4,8,14) F2(a,b,c,d) =Sm(4,11

Transformer, Why we provide the short circuit and open circuit test in tran...

Why we provide the short circuit and open circuit test in transformer

Diodes, Analysis of diode circuits

Analysis of diode circuits

Explain the signals hold and sid, Explain the signals HOLD, READY and SID ...

Explain the signals HOLD, READY and SID HOLD indicates that a peripheral such as DMA controller is requesting the use of address bus, data bus and control bus. READY is used to

Calculate the voltage across the capacitor, In the circuit above, V1 is a d...

In the circuit above, V1 is a dc supply which outputs 12V, R1 has a value of 100 Ω and C1 is 100µF. The switch has been left in the position shown for a long time such that there i

Personal safety from power, Personal  safety Power supplies can be very...

Personal  safety Power supplies can be very dangerous. This is specifically true of high voltage circuits, but anything over 12 V must be treated as lethal potentially. A po

Determine transformer turns ratio, A flyback converter is to be designed so...

A flyback converter is to be designed so that it operates in continuous "current" (flux) mode with a duty cycle of D = 0.45 when input voltage V s = 48 V, output voltage V o = 30

Addition of two sinusoids, Connect the 2 kHz (sin ωt) signal to input A of ...

Connect the 2 kHz (sin ωt) signal to input A of the "Adder" module Connect input B to ground (GND). Connect the outputof the"Adder"(GA+gB) to input A-CH1 of "Scope Selector".

Give a brief description of integrating circuits, Q. Give a brief descripti...

Q. Give a brief description of integrating circuits ? Integration is a summation of area. An integrating circuit produces an output voltage which is proportional to the area en

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd