What is the routing algorithm used by rip and igrp, Computer Networking

Assignment Help:

Distance vector-based routing algorithms (also called as Bellman-Ford algorithms) pass periodic copies of a routing table from router to router. Regular updates among routers communicate topology changes. Every router receives a routing table from its direct neighbour and increases all learned routes by one. By this method, every router learns the internetwork topology by second hand information.

Related Discussions:- What is the routing algorithm used by rip and igrp

frames along with the rtp, For VOIP, first you need to consider the codec ...

For VOIP, first you need to consider the codec to use. Although there are many voice codecs, MyCo wants the safest bet and suggests that you design with the most known and oldest c

Firewall architectures-dual homed host architecture, Dual Homed Host Archit...

Dual Homed Host Architecture This setup consists of a host machine with two or more IP addresses for each of its physical port. One port is connected to intranet and other to the

Explain collision, When the signal hits to each other, collision accord.

When the signal hits to each other, collision accord.

Describe about the noiseless channel, Describe about the noiseless channel ...

Describe about the noiseless channel A noiseless channel can transmit an arbitrarily large amount of information, no matter how frequently it is sampled. Just send a lot of dat

Packet traser , hi

Define client and server, Question 1 Define client and server. Explain the...

Question 1 Define client and server. Explain the Client server model Question 2 What is a Mainframe System? Write down the features of Mainframe System Question 3

Bridges, BRIDGES: A bridge is a hardware device also needed to connec...

BRIDGES: A bridge is a hardware device also needed to connect two LAN code segments to extend a LAN. A bridge uses two NICs to connect two code segments. It listens to all tr

State 802.11 DSSS , 802.11 DSSS a) Direct sequence spread spectrum in a...

802.11 DSSS a) Direct sequence spread spectrum in a 2.4 GHz band b) Each bit is replaced by a sequence of bits called a chip code, implemented at the physical layer c) Se

Comp architecture, In reg-mem architecture, clock cycle is 10 ns wide. It i...

In reg-mem architecture, clock cycle is 10 ns wide. It is proposed that reg-reg architecture be used instead, that reduces the clock cycle by 2 ns. However, it requires an addition

Explain in brief about crc, What is CRC The CRC is computed while trans...

What is CRC The CRC is computed while transmission and appended to output stream as soon as last bit goes out onto wire. If the CRC were in header, it will be necessary to make

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages