What is round trip time, Computer Networking

Assignment Help:

What is Round Trip Time?

The duration of time it takes to send a message from one end of a network to the other and back, is known as RTT.

 


Related Discussions:- What is round trip time

Illustrate the drawbacks of stop and wait, Q. Illustrate the Drawbacks of s...

Q. Illustrate the Drawbacks of stop and wait? Drawbacks of stop and wait - Only one frame is able to be in transit at a time - After every frame sent the host must wai

Which steps are used at receiver end by check sum, Q. Which steps are used ...

Q. Which steps are used at receiver end by check sum? The receiver follows these steps: The unit is divided into "k" sections each of "n" bits All sections are

Explain the term hardware cost, Hardware Cost It indicates to the cost ...

Hardware Cost It indicates to the cost concerned in the functioning of an interconnection network. It comprises the cost of arbiter unit, connectors, switches, interface logic

Show the refraction and reflection in Fiber-optic cable , Q. Show the Refra...

Q. Show the Refraction and Reflection in Fiber-optic cable ? - Refraction often takes place when light bends as it passes from one medium to another less dense medium - Wh

Features of transmission control protocol, The major features of TCP are fo...

The major features of TCP are following: Reliability : TCP ensures that any data sent by a sender arrives at the destination as it was sent. There cannot be any data loss or mo

describe the mips instructions - computer architecture, 1.  Detail for eac...

1.  Detail for each of the four following MIPS instructions, which actions are being taken at each of their five steps.  Do not forget to mention how and during which steps each in

Explain collision, When the signal hits to each other, collision accord.

When the signal hits to each other, collision accord.

Process management in pvm, Process Management int pvm_mytid( void ...

Process Management int pvm_mytid( void ) Returns the tid of the calling process.  tid values less than zero indicate an fault. int pvm_exit( void ) T

Udp connection establishment & termination, simple introduction,defination ...

simple introduction,defination and with example & digram

Show the congestion control in TCP, Q. Show the Congestion control in TCP? ...

Q. Show the Congestion control in TCP? Congestion control in TCP TCP assumes that the cause of lost segment is due to congestion in the network Retransmission of

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd