What is input - output commands, Computer Engineering

Assignment Help:

Q. What is Input - Output commands?

There are four kinds of I/O commands which an I/O interface can receive when it's addressed by a processor:

  • Control: This type of commands is device specific and is used to give specific instructions to device for example a magnetic tape requiring rewinding and moving forward by a block.
  • Test: This command checks status like if a device is ready or not or is in error condition.
  • Read: This command is helpful for input of data from input device.
  • Write: this command is employed for output of data to output device.

 


Related Discussions:- What is input - output commands

What is the linkage section, The linkage section is part of a known as prog...

The linkage section is part of a known as program that 'links' or maps to data items in the calling program are working storage. It is the part of the called program where these sh

Knowledge of the environment - artificial intelligence, Knowledge of the E...

Knowledge of the Environment: We must discriminate between knowledge an agent receives through its sensors and knowledge about the world from which the input comes. The world

Explain half-adder with truth-table and logic diagram, What is a half-adder...

What is a half-adder? Explain a half-adder with the help of truth-table and logic diagram. Ans. Half Adder: It is a logic circuit for the addition of two 1-bit numbers is term

What are the process states in unix, What are the process states in Unix? ...

What are the process states in Unix? As a process implements it changes state according to its circumstances. Unix processes have the following states: Running : The process

Computer architecture by henessy and patterson, what is initial interval an...

what is initial interval and latency in a functional unit(fp) of a pipeline

Low on the data-input line, For the 8-bit bidirectional register in Figure ...

For the 8-bit bidirectional register in Figure 3, verify the status of the register after every clock pulse for the LEFT RIGHT /control waveform given. A HIGH on this input permits

Explain the architecture of ss7, Explain the architecture of SS7 . A ...

Explain the architecture of SS7 . A block schematic diagram of the CCITT no. 7 signaling system is demonstrated in figure. Signal messages are passed by the central proces

Interaction design and human–computer interaction, You should now have a re...

You should now have a reasonably clear understanding of what is meant by interaction design. However, there are several other terms which are often used to refer to particular aspe

Determine the registers are available in machines, Determine the registers ...

Determine the registers are available in machines Typical registers, some of which are commonly available in machines. These registers are as follows:- Memory Addres

Explain overlay structured program, Explain overlay structured program ? ...

Explain overlay structured program ? A program having overlays is termed as overlay structured program, here an overlay is a part of program that has similar load origin as som

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd