What is indirect extrusion, Mechanical Engineering

Assignment Help:

Q. What is Indirect extrusion?

In indirect extrusion, also known as backwards extrusion, the billet and container move together while the die is stationary. The die is held in place by a "stem" which has to be longer than the container length. The maximum length of the extrusion is ultimately dictated by the column strength of the stem.

2402_What is Indirect extrusion.png


Related Discussions:- What is indirect extrusion

Shear force.., A cantilever beam of 1800 mm length is subjected to point lo...

A cantilever beam of 1800 mm length is subjected to point loads of 3.5 kN, 4.3 kN, 1.2 kN and 2.8 kN at distances of 400 m, 400 m, 400 m 300 m and 300 m, respectively from the fixe

Bench vices tool and equipment , Bench Vices: Bench vice is used to hold a...

Bench Vices: Bench vice is used to hold a job on a bench. It consists of a movable jaw, a fixed jaw, spindle and a lever. Figure shows a bench vice. The movable jaw is in the fron

Slip-on flanges, Slip-On Flanges Slip-on flanges are limited to use und...

Slip-On Flanges Slip-on flanges are limited to use under the following conditions: ASME/ANSI B16.5 standard forged flanges for design pressures and coincident temperatures n

Electrode wire for co2 welding, ELECTRODE WIRE FOR CO2 WELDING CO 2 we...

ELECTRODE WIRE FOR CO2 WELDING CO 2 welding wire must have a special composition to withstand the oxidising nature of the CO 2 arc atmosphere. Though, CO 2 is not reactive a

Need of a spectrophotometer, Need of a spectrophotometer: The specific...

Need of a spectrophotometer: The specific instructions will differ with other models, but the principles remain. 1. The instrument must have been warm for at least 15 min.

Kinematics, Kinematics: We have seen the various types of motions whic...

Kinematics: We have seen the various types of motions which may be undergone by particles and rigid bodies. You may be able to understand the relationships of displacement, ve

Typical joint designs used in electron beam welding, TYPICAL JOINT DESIGNS ...

TYPICAL JOINT DESIGNS THAT ARE USED IN ELECTRON BEAM WELDING Butt joint : Butt joint is the preferred joint as it involves only a small amount of machining prior to wel

Illustrate the specification of pddi, Illustrate the specification of PDDI ...

Illustrate the specification of PDDI (i)  The 3-D geometry of the product which is defined by a set of curves, surfaces and volumes. (ii) The topology which describes the se

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd