What is a control word, Electrical Engineering

Assignment Help:

What is a control word?

It is a word kept in a register (control register) used to control the operation of a program digital device.

 


Related Discussions:- What is a control word

Why do we cascade amplifiers, Q. Why do we cascade amplifiers? Why is RC co...

Q. Why do we cascade amplifiers? Why is RC coupling the most widely used coupling between 2 stages of a cascading amplifier? The voltage or power gain or frequency response obt

Lhld load hl pair direct instruction, LHLD  Load  HL Pair Direct  Instru...

LHLD  Load  HL Pair Direct  Instruction This  instruction is used to copy the  content  of memory  location specified  by opened  in register L  and copy the content of next  m

Critical rate of rise of voltage - thyristor , Critical Rate of Rise of Vol...

Critical Rate of Rise of Voltage It  depends on  the junction temperature higher  the junction  temperature lower  the critical rate of  rise of  voltage. It is also known  as

Increase in ht and lt ratio, Increase in HT and LT Ratio It is well kn...

Increase in HT and LT Ratio It is well known that for high HT/LT ratio, the losses will be low. The losses for a given quantum of power supplied through a line are inversely p

Find the minimum practical value frequency, A radar systemuses pulses of du...

A radar systemuses pulses of duration D tomodulate the amplitude of a radio carrierwave. The system can distinguish between targets spaced apart by a distance of d ≥ cD, where c is

Determine lower and upper cut-off frequency, Q. In an amplifier, the maximu...

Q. In an amplifier, the maximum voltage gain is 1500 and occurs at 1kHz. It falls to 1060.5 at 20kHz and at 20Hz. Determine (i) lower cut-off frequency (ii) upper cut-o

Find the approximate values of gain and phase margins, Q. Sketch the asympt...

Q. Sketch the asymptotic Bode plots for the following loop-gain functions, and find the approximate values of gain and phase margins in each case.

What are the signals involved in memory bank selection, What are the signal...

What are the signals involved in memory bank selection in 8086 microprocessor? The 8086 based system will have two sets of memory IC's. One set for even bank and another for od

Evaluate the transfer function for multi loop control system, Q. The block ...

Q. The block diagram of Figure represents a multi loop control system. (a) Determine the transfer function C(s)/R(s). (b) For G 2 G 3 H 2 = 1, evaluate C(s)/R(s).

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd