Command that forces the router to load into ROM, Computer Networking

Assignment Help:

Determine the command that forces the router to load into ROM mode upon a reload? 

Ans) boot system rom ia the command that forces the router to load into ROM mode upon a reload

 

 


Related Discussions:- Command that forces the router to load into ROM

Explain about traditional modems, Q. Explain about Traditional Modems? ...

Q. Explain about Traditional Modems? - Subsequent to modulation by the modem an analog signal reaches the telephone company switching station where it sampled and digitized to

Case study, #questi Scenario: Your Case Study must be based on the informat...

#questi Scenario: Your Case Study must be based on the information provided. There will be no additional information. This must be submitted in a .doc, or .pdf format. If you sen

Difference between baseband and broadband transmission , What is difference...

What is difference between Baseband and Broadband Transmission in ccna? Ans) In a baseband transmission, the entire bandwidth of the cable is consumed by a one signal. In bro

What is tcp/ip, What is TCP/IP TCP/IP is short for Transmission Control...

What is TCP/IP TCP/IP is short for Transmission Control Protocol / Internet Protocol. This is a set of protocol layers that is intended to make data exchange possible on dissim

Disadvantages of ip sec tunnelling mode, Disadvantages of IP sec  Tunnelli...

Disadvantages of IP sec  Tunnelling mode IP sec  tunnelling  mode has the  following  disadvantage a.Encryption of  small  packets  generates a lot  networks  over head  thu

What do you understand by service access point, Q. How two adjacent layers ...

Q. How two adjacent layers communicate in a layered network or what do you understand by Service Access Point? Ans: In layered network, each layer has several entities and enti

Process server, Using a process server (such as inetd or xinetd) to listen ...

Using a process server (such as inetd or xinetd) to listen on a set of well-popular ports and start one another server.  I said that it had much to do with overhead.  Say you set u

the default settings of ipx delay number, The "ipx delay number" command w...

The "ipx delay number" command will permit an administrator to alter the default settings. Explain the default settings? Ans) For LAN interfaces, one tick; for WAN interfaces, s

Explain about bridges, Bridges The bridge function is to attach separat...

Bridges The bridge function is to attach separate homogeneous networks. Bridges map the Ethernet address of the nodes residing on each network segment and allow only essential

State about the cell sectoring, State about the Cell sectoring With cel...

State about the Cell sectoring With cell sectoring, a cell is separated into a number of wedge-shaped sectors, each with its own set of channels, typically 3 or 6 sectors per c

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd