What are the signals used in input control signal, Electrical Engineering

Assignment Help:

What are the signals used in input control signal & output control signal?

Input control signal

STB (Strobe input)

IBF (Input buffer full)

INTR(Interrupt request)

Output control signal

OBF (Output buffer full)

ACK (Acknowledge input)

INTR(Interrupt request)

 


Related Discussions:- What are the signals used in input control signal

Describe about boltzmann constant, Q. Describe about Boltzmann constant? ...

Q. Describe about Boltzmann constant? The constant η in Figure (b) stands for the noise power spectral density, expressed in terms of power per unit frequency (W/Hz). Statistic

Calculation of receiving end voltage, Calculation of Receiving End Voltage ...

Calculation of Receiving End Voltage Consider the simple circuit shown in Figure. To find the voltage V 2 using analytical method:   P = I V 2 = 0.5      ..... (1)

Explain the term half duplex transmission, Explain the term half duplex tra...

Explain the term half duplex transmission. A half duplex channel can receive and send, but not at similar time. It's as a one-lane bridge where two-way traffic should give way

Motor windings, What is the main function of dummy coul in winding?

What is the main function of dummy coul in winding?

Use of a k map simplify the following boolean expressions, Q. With the use ...

Q. With the use of a K map, simplify the following Boolean expressions and draw the logic diagram.

What is output impedance, Q. What is Output Impedance? Output Impedance...

Q. What is Output Impedance? Output Impedance : The output impedance of an amplifier is a measure of the impedance or resistance. It has nothing to do with the actual loading t

Determine whether the diode in circuit, Determine whether the diode (consid...

Determine whether the diode (considered to be ideal) in the circuit of Figure (a) is conducting.

Mobile and wirelss communicatio, In a CDMA system, the signal is spr...

In a CDMA system, the signal is spread over a large bandwidth by multiplying the transmitted symbol by a sequence of short pulses, also called chips. The

Calculation of aggregate technical and commercial loss, Calculation of Aggr...

Calculation of Aggregate Technical and Commercial Loss The concept of AT&C loss was introduced within 2001-02. The AT&C losses are presently in the range of 18% to 62% in seve

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd