What are the instructions to charge a battery?, Mechanical Engineering

Assignment Help:

(a) How is specific gravity of electrolyte (battery water) measured and what should be the value of specific gravity?
(b) How would you measure battery voltage and what is its recommended value?
(c) What are the instructions to charge a battery?


Related Discussions:- What are the instructions to charge a battery?

Expression for condition of maximum discharge, Drive an mathmatical express...

Drive an mathmatical expression for condition of maximum discharge through the chimney. Dry saturated steam is supplied from a boiler to a steam engine at a pressure of 15 bar.

Dynamic Force Analysis, How to determine Forces and Torque of slider crank ...

How to determine Forces and Torque of slider crank mechanism?

Engineering design, 1) State five factors that must be considered when choo...

1) State five factors that must be considered when choosing a material. Discuss the importance to the engineer of each of these factors. 2) An engineer is planning to design a s

What is pressure testing, Q. What is Pressure Testing? Pressure test sh...

Q. What is Pressure Testing? Pressure test shall be performed after completion of all welds and the PWHT of the boiler. Prior to final inspection and pressure test, the insi

2 degree freedom of system, A mechanical System (two degrees of freedom sys...

A mechanical System (two degrees of freedom system) is represented by the following two differential equations: m1x"1+(k1+k2)x1-k2x2=0 m2x"2-k1x1+(k2+k3) x2=0 Given m1=m2=0.5kg, k

Thermodynamics, steam coming out of the whistle of a pressure cooker is ?

steam coming out of the whistle of a pressure cooker is ?

Condition for carnot theorem - thermodynamics, Condition for Carnot theorem...

Condition for Carnot theorem - thermodynamics: 1 .   If T 1  = T 2 ; No work, = 0 2 .   Higher the temperature difference, greater the efficiency. 3.   For the same

What is isometric drawing, It is a 3-D drawing used by draftsmen, architect...

It is a 3-D drawing used by draftsmen, architects etc

Strength of materials, derive the torsion formula as (torsion divided by ra...

derive the torsion formula as (torsion divided by radius) is equal to (modulus of rigidity multiplied by twist of angle all divided by the length of a cylinder)

Cam, advanced cam profile synthesis

advanced cam profile synthesis

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd