What are the drawbacks of microprocessor, Electrical Engineering

Assignment Help:

There is a limitation on the size of data. Most Microprocessor does not maintain floating-point operations.          

 

 


Related Discussions:- What are the drawbacks of microprocessor

Control signals - pins and signals , Control Signals There are two  con...

Control Signals There are two  control  signals and one  special  (ALE) in this  category. All these  signals  are output  signals. RD  (Read  signal ) it is  an active low

Define resistance in lumped-circuit, Q. Define Resistance in lumped-circuit...

Q. Define Resistance in lumped-circuit? An ideal resistor is a circuit element with the property that the current through it is linearly proportional to the potential differenc

Distributed Control Sytems, 1. Produce a fully-labelled sketch to show the ...

1. Produce a fully-labelled sketch to show the components of a Direct Digital Control system. 2. State the minimum number of printed-circuit cards required to construct a basic co

Calomel electode, Explain the construction and working of Calomel electrode...

Explain the construction and working of Calomel electrode

Determine the apparent power and the reactive power, Q. A balanced electric...

Q. A balanced electrical industrial plant load of 9.8 MW with 0.8 lagging power factor is supplied by a three-phase 60-Hz system having a maximum rating (load-carrying capacity) of

Telecommunication, Design a low noise amplifier using an Infineon RF transi...

Design a low noise amplifier using an Infineon RF transistor BFP640. The amplifier is to be used to amplify the L2 GPS signal and so the centre frequency is 1227MHz and bandwidth 4

The filter capacitor , It is needed to use a half-wave rectifier for a dc p...

It is needed to use a half-wave rectifier for a dc power supply that gives an average dc output voltage of 15 V and a maximum ±1V ripple is permitted. The rectifier feeds a load of

Describe watch dog timer and reaction timer, a. Given a timer with a termin...

a. Given a timer with a terminal count and a clock frequency of 10 MHz measure the following: (i) Range & Resolution (ii) Terminal count values needed to measure 3ms interval

Draw frequency response curve, Q. Sketch An Rc Coupled Two Stage Amplifier....

Q. Sketch An Rc Coupled Two Stage Amplifier. Draw Its Frequency Response Curve And Account For Its Stages. The figure above shows a two stage RC coupled amplifier. The sig

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd