Welding head, Mechanical Engineering

Assignment Help:

Welding Head

Submerged arc welding head consists of the wire spool, wire feed system, flux delivery hopper and electrical contact nozzle. The electrode wire is unwound from the spool by the power driven rolls, straightened by a set of pressure rolls and fed through the contact nozzle into the weld pool. The drive for wire feed is from a motor with speed control provided either by means of a gear box or by means of thyristor controls.


Related Discussions:- Welding head

Strain, is strain in bending important parameter to consider?

is strain in bending important parameter to consider?

Compare rankine cycle with carnot cycle - thermodynamics, Compare Rankine c...

Compare Rankine cycle with Carnot cycle: Sol.: Rankine cycle without superheat: 1 - A - 2 - 3 - 4 - 1. Rankine cycle with superheat : 1 - A - 2 - 2′ -3′ - 4 - 1.

Piston rings-basic components of engine , Piston Rings: Piston rings (Fig...

Piston Rings: Piston rings (Figure), fitted into the grooves around the piston, provide a tight sealing effect between the piston and the cylinder wall thus preventing leakage of

Explain bevel gear generating process, Explain Bevel Gear Generating Proces...

Explain Bevel Gear Generating Process? The fundamental of bevel gear generating process involves the rolling of a bevel gear blank on a crown wheel. The crown wheel is a bevel

Equivalent force system - mechanics, Equivalen t force System: An equ...

Equivalen t force System: An equivalent system for the given system of coplanar forces is the combination of force passing through given point and moment about that point. Th

Determine the core radius of a multi-mode, Modal Dispersion in Step-Index F...

Modal Dispersion in Step-Index Fibers Determine the core radius of a multi-mode step index fiber with a numerical aperture NA = 0.1 if the number of modes M = 5000 when the wave

Determine change in length of the bar, Determine change in length of the ba...

Determine change in length of the bar: A steel bar is subjected to loads as shown the given figure. Determine change in length of the bar ABCD of 18 cm diameter. E = 180

Optimization, what are the different method for worm gear optimization

what are the different method for worm gear optimization

Show bolt material, Q. Show Bolt Material? Bolt material must be select...

Q. Show Bolt Material? Bolt material must be selected with adequate yield strength at the operating temperature to provide the required strength to properly seat the gasket. It

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd