Welding, Mechanical Engineering

Assignment Help:
Differentiate between porosity & blowholes in welding

Related Discussions:- Welding

What are the types of interface, What are the Types of interface An int...

What are the Types of interface An interface can be regarded as an aggregate of conditions, rules and conventions which describes the information exchange, between two communic

Identification of pressure welds, Q. Identification of Pressure Welds? ...

Q. Identification of Pressure Welds? Pressure welds shall be identified as follows: a. Generally each weld shall be stamped adjacent to the weld with the welder's identity c

Determine the point of intersection jets, A tank has two identical orifices...

A tank has two identical orifices in one of its vertical sides. The upper orifice is 3m below the water surface and lower one is 5m below the water surface. If the value of Cv for

Balancing, basics of static balancing.

basics of static balancing.

HW engineering Statics, Hello, I need some assistance in solving engineerin...

Hello, I need some assistance in solving engineering statics problems. In the following link, I have uploaded seven questions. I need help solving these problems step-by-step. I

What is coating thickness, Q. What is Coating Thickness? The dry thickn...

Q. What is Coating Thickness? The dry thickness of the coating shall be checked by using a "micro test" magnetic gauge or approved equal which has been properly calibrated, at

What is shatter test, Q. What is Shatter test? Shatter test: This tes...

Q. What is Shatter test? Shatter test: This test is measure of toughness of the moulding sand. It indicates the capacity of the moulding sand to with stand rough handling dur

Necessity of electrical system , Necessity of Electrical System Li...

Necessity of Electrical System Lights and horn for safe riding of vehicle even at night. Electricity for ignition of fuel in the engine. Battery Charging.

Mig / co2 welding, MIG / CO 2 WELDING In MIG / CO 2 welding the feed...

MIG / CO 2 WELDING In MIG / CO 2 welding the feeding of filler wire is machanised. If the welder moves the MIG / CO 2 torch the process is called semi automatic MIG / CO 2

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd