Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Q. Ultrasound Bolt Load Monitoring?
Ultrasound measurement of bolt stresses, using ‘Bolt Scope', should be used on:
• All bolts tightened by tensioning.
• All bolts in hydrogen service.
• All bolts in hydrocarbon service with pressure rating Class 900 and above.
• Bolt sizes ¾ in (20 mm) and larger in critical service.
A minimum of 20% of the bolts shall be tested.
To ensure required accuracy and field efficiency, proper preparation of stud ends must be provided. Stud ends must be machined flat and parallel.
Determine the Loss of Information During Exchange in IGES Loss of Information During Exchange : Information would inevitably be lost when information is passed between two CAD
Q. Show Material selection process? • Design life shall be based on project design criteria and normally 10 to 15 years' service life specified for well pads, 20-25 years for C
Application of Cost-Volume-Profit Relationships: Quality stores open for 10 hours a day. Company is considering decreasing the store hours through one hour. This shall resul
Compute the displacement of the particle: The acceleration time diagram for particle is as specified below .Computed velocity of the particle at several time intervals, plot v
The figure shows a particular point of the connecting rod BA and crank AO. At this position the rod the engine exacts a force 2500N on the crank oin at A. Resolve this force into h
Creep: Creep of rails is the forward movement of rails in the direction of dominant traffic over a period of time. Creep is undesirable because it disturbs the gauge of the t
proell governor,porter governor,watt governor
(a) Specify, giving reasons whether the following systems are closed, open or isolated when in operation (i) Kitchen Refrigerator (ii) Ice-cream freezer (iii) Scooter Engi
Crank Pin and Crank Shaft - Part of combustion engine: Cran k Pin: Crank pin is region on crank shaft on which big end of connecting rod is attached. These pins are eccentr
Determine the final temperature in piston – cylinder: One Kg of steam at 1.5MPa and 400ºC in a piston - cylinder device is cooled at constant pressure. Determine the final te
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd