ottto cycle, Mechanical Engineering

Assignment Help:
For a theoretical OTTO cycle operating on compression ratio of 8.5:1taking in air at 15C and 101.3kPa and having a maximum cycle temp of 1800C.Calculate the temp after compression,the temp after expansion,the theoretical work of compression per kg of air,the theoretical work of expansion per kg of air,the network per kg of air,the net heat supplied per kg of air,the theoretical cycle efficiency.

Related Discussions:- ottto cycle

Site selection - planning a new airport, Site Selection: The followi...

Site Selection: The following consideration govern the choice of site for an airport : (a)        The area served must be able to generate and attract the estimated passen

Determine strap beam with suitable demonstration, Determine strap beam with...

Determine strap beam with suitable demonstration. Here observe that R e becomes greater than P e by a magnitude of V while R i becomes less than P i by a magnitude equal to

Calculate values of ki - thick cylinder, Calculate values of KI - thick cyl...

Calculate values of KI - thick cylinder: If cracks of 6 mm and 12 mm length are separately present only one side of inner surface in radial direction find two values of KI.

Determine shear plane angle, The following data was obtained from an orthog...

The following data was obtained from an orthogonal cutting test : Rake angle = 20o, Depth of cut = 6 mm Feed rate = 025 mm/rev Chip length before cutting = 29.4 mm Chip

Nozzle and turbine - thermodynamics, Nozzle: The pressure energy gets ...

Nozzle: The pressure energy gets converted in to kinetic energy Mass flow rate  Turbine: It is used to generate work.  The work is done by system becaus

Shaft in parallel, SHAF T IN PARALLEL: SHAF T IN PARALLEL: The sh...

SHAF T IN PARALLEL: SHAF T IN PARALLEL: The shaft are in parallel when the driving torque is applied at the junction of shafts and resisting torque is at other ends of

Define conceptual engineering phase for project, Q. Define Conceptual Engin...

Q. Define Conceptual Engineering Phase for project? The primary objective of this stage is to include and clearly define the economic feasibility of the project, sensitivity to

How to calculate coupling factor?, Q. Two coils with self inductances 1H an...

Q. Two coils with self inductances 1H and 4H have a mutual inductance of 1H. The RMS value of current flowing in the two coils is 4A and 1A respectively. Find  the coupling factor

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd