Cement Sand Plaster, Civil Engineering

Assignment Help:

How to use plaster cement in sand? 

Cement sand plaster is a layer of cement & sand mortar that is applied over walls made of brickwork, cement block work, RCC walls and RCC columns or beams.  

The plaster can be classified into 2 basic categories

1. Interior plaster as specified by interior designers is mainly smooth finish & 12mm thick (or can have rough keyed surface to receive other material like tile or stone cladding)

2. Exterior plaster that is applied on building facades, compound walls and others. is usually 24 mm thick & is applied in 2 coats of 12 mm each. The top coat is normally rough finish with a sand grain texture.

 


Related Discussions:- Cement Sand Plaster

Determine the magnetic declination at a place, Example : Determine th...

Example : Determine the declination at a place, if at noon the magnetic bearing to the sun is (a) 358° (b) 185° Solution: (a) Referring to given figure (a) since the ma

Road and traffic engineering(signal timing design), what are the basic assu...

what are the basic assumption of traffic flow model and capacity model used in signal timing design ? discuss

Constraction, sir what is means by share force

sir what is means by share force

Explain about catch sidings, Q. Explain about Catch Sidings? Normally a...

Q. Explain about Catch Sidings? Normally all catch sidings except those which are sanded shall be kept alive. On sanded catch siding, the rails shall be kept clear of sand for

Resultant pull, two locomotive moving on opposite bank of a canal can pull ...

two locomotive moving on opposite bank of a canal can pull a vessal parallel to the banks by the means of two rope.the force in the ropes are 20kN and 24kN while the total angle be

State the term - terminology, State the term - Terminology There are ma...

State the term - Terminology There are many technical terms whose understanding provides us with a good insight of  the subject. Some of  these terms are, indeed, general and t

Maximum shear stress , the propane gas tank has an inner diameter of 1500mm...

the propane gas tank has an inner diameter of 1500mm and wall thickness of 15mm. If the wall is pressurized to 2MPa, determine the absolute maximum shear stress in the wall of tank

Premix, how we can do good premix

how we can do good premix

Design the 2-span continuous center, Design the 2-span continuous center T-...

Design the 2-span continuous center T-beam, B2, for the floor syetem shown below. The girders that the beam frames into are all 24" wide. Using fc'= 5 ksi, and fy = 60 ksi. The ser

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd