Throttle free play adjustment of motor cycle, Mechanical Engineering

Assignment Help:

Throttle Free Play Adjustmen: A smooth operation of the throttle ensures proper acceleration of the vehicle according to the requirement of the rider. If the throttle cable is kinked, chafed or improperly routed, it should be replaced or re-routed.

STEPS

  • Throttle free play is checked by rotating the throttle grip. It should be between 2-6 mm.
  • If required the lock nut is loosen and the throttle adjusting nut is moved clockwise or anticlockwise to increase or decrease the free play.
  • Check the throttle cable for correct routing.
  • If throttle cable is damaged it should be replaced.

Important points to remember :

  • Throttle free play must be between 2-6 mm.

 


Related Discussions:- Throttle free play adjustment of motor cycle

Shaft in series, SHAF T IN SERIES : In order to form composite sh...

SHAF T IN SERIES : In order to form composite shaft sometimes 2 shafts are connected in series. In this type of cases each shaft transmits same torque. The angle of twist

Applied chemistry, hardness of bore well water is less than sea water .just...

hardness of bore well water is less than sea water .justif

Currency bull spread and bear spread, Currency Bull Spread and Bear Spread:...

Currency Bull Spread and Bear Spread: A currency bull spread is constructed by buying a call option for a particular underlying currency and simultaneously writing a call opti

Determine in detail about the depth of foundation, Location with Respect to...

Location with Respect to Depth The depth below ground level at which the bottom of a foundation structure is located depends on number of factors, the most important of which

Design requirements for aircraft access, Q. Design requirements for Aircraf...

Q. Design requirements for Aircraft Access? For some remote locations, provision may be required for occasional landing of aircraft during emergencies or executive visits. Thes

Seam welding, Seam Welding Seam welding is different from spot welding ...

Seam Welding Seam welding is different from spot welding by the fact that roller type electrodes are used in the former case. The principle and process of welding are the same

What are objectives of the footings, What are objectives of the footings? ...

What are objectives of the footings? Objectives of the footings: After studying this unit, you should be able to: a. Know different types of footings and the situation wh

Essentials of a good boiler , ESSENTIAL S OF A GOOD BOILER: -     Sho...

ESSENTIAL S OF A GOOD BOILER: -     Should be capable of producing the required Steam at   the required pressure for minimum fuel required. -     Should be capable of stan

Connected rod - part of combustion engine, Connecte d Rod: It is att...

Connecte d Rod: It is attached to piston at its small end by means of gudgeon pin. The big end bearing is connected to crank pin. It is made up of forged steel.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd