Techniques and resources in problem base learning, Electrical Engineering

Assignment Help:

Techniques and resources

Different techniques and resources were used in different areas of the problem during the course of the project.

The most important of them was the use of simulating package called proteus. The testing of a program and a circuit in physical was a tedious task. So proteus was for testing by simulating the design in it. It is really easier to redraw or modify a circuit and it has all the components required for the circuit construction.

If the circuit was soldered on a veroboard, it would have been time consuming and prone to faults. So the team thought of using the PCB as it was much easier. The circuit designs of the remote and the receiver were printed on a PCB and it helped save a lot of time as the whole circuit was soldered in a matter of minutes.

 


Related Discussions:- Techniques and resources in problem base learning

Determine the line-to-line voltage, Q. A one-line diagram of a three-phase ...

Q. A one-line diagram of a three-phase distribution system is given in Figure. Determine the line-to-line voltage at the sending end of the high-voltage feeder when the transformer

Write a control word for counter 1 of 8253 / 8254, Write a control word for...

Write a control word for counter 1 of 8253 / 8254 that selects the following options:  load least significant byte only, mode 5 of operation and binary counting.  Then write an ins

Depletion in mosfert, #Minimum 100 words accepted#explain depletion operati...

#Minimum 100 words accepted#explain depletion operations of MOSFET

Consider four cases of operation and explain jk flip-flop, Q. J and K are t...

Q. J and K are the external inputs to the JKFF shown in Figure. Note that gates 1 and 2 are enabled only when the clock pulse is high. Consider the four cases of operation and expl

Live human detection robot, which simulation software is better for this p...

which simulation software is better for this project, and how can i simulate it?

Find in wavelengths how long the line, Q. A transmission line with air diel...

Q. A transmission line with air dielectric is 25 m long. Find, in wavelengths, how long the line is at frequencies of 1 kHz, 10 MHz, and 100 MHz.

Determine the value of the capacitance in single phase, Q. Three loads in p...

Q. Three loads in parallel are supplied by a single phase 400-V, 60-Hz supply: Load A: 10 kVA at 0.8 leading power factor Load B: 15 kW at 0.6 lagging power factor Load C:

Determine the required voltage at the high-voltage terminals, Q. A 20-kVA, ...

Q. A 20-kVA, 2200:220-V, 60-Hz, single-phase transformer has these parameters: Resistance of the 2200-V winding R1 = 2.50  Resistance of the 220-V winding R2 = 0.03  Lea

What are advantages of segmentation, What are advantages of segmentation...

What are advantages of segmentation ? However because the segment register is 16 bit broad and the memory requires 20 bits for an address the 8086 appends 4 bits segment reg

Sonic harassment, Sir I would like to find a sensor that can detect beams ...

Sir I would like to find a sensor that can detect beams from the phasor painfield generator and the sonic devasator (devices of this nature). These sonic devices emit a high pres

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd