State - thermodynamics, Mechanical Engineering

Assignment Help:

STATE - Thermodynamics:

The State of system is its condition or configuration described in detail.

State is the condition of the system which is identified by thermodynamic properties such as pressure, temperature, etc. The number of properties needed to describe a system depends upon nature of system. However each property has single value at each state. Each state can be represented by point on graph with any two properties as coordinates.

Any operation in which one or more properties of a system change is called as change of state.

 


Related Discussions:- State - thermodynamics

Motion of a solid particle, With the aid of a sketch, describe the motion o...

With the aid of a sketch, describe the motion of a solid particle settling in a liquid and discuss the effect on it of applying a centrifugal force. Define the terms Separating

Carnot theorem and efficiency - thermodynamics, Carno t Theorem: No h...

Carno t Theorem: No heat engine operating in cycle between the two given thermal reservoir, having fixed temperature can be more efficient than reversible engine operating be

Explain about the pedestals as construction engineering, Explain about the ...

Explain about the pedestals as construction engineering. Introduction of pedestals enables the construction engineers to make up levels to supply larger bearing areas to the fo

Determine thermal contact resistance, Derive the mathematical Heat Conducti...

Derive the mathematical Heat Conduction equation through a composite wall. Determine Thermal contact Resistance ?

Maximum shear stress, An aircraft flap actuator housing made of cast magnes...

An aircraft flap actuator housing made of cast magnesium alloy ZAG3A-T4 with uniaxial yield strength σ Y = 14,000 psi.  At the suspected critical point the calculated state of str

Define rack cutter generating process, Define Rack Cutter Generating Proces...

Define Rack Cutter Generating Process? The rack cutter generating process is also called shaping process. In this method, the generating cutter has the foam of basic rack for t

Welding, difference between pinhole and porosity

difference between pinhole and porosity

Draw the bending moment and shear force diagram, Draw the bending moment an...

Draw the bending moment and shear force diagram for the following cases : a) A cantilever beam of length (L) carrying a Point load (W)at its free end. b) A simply supported b

Homogeneous and isotropic material, Homogeneous and isotropic material: ...

Homogeneous and isotropic material: A homogeneous material implies that elastic properties like modulus of elasticity and Poisson's ratio of material are same everywhere in

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd