State the planning the foundation for reciprocating engines, Mechanical Engineering

Assignment Help:

State the Planning the foundation for reciprocating engines

i)  The eccentricity of  the common centre of gravity of machine and foundation referred to the centroid of base area should not exceed 5% of  the corresponding base dimension of  the foundation.

ii)  To decrease the transmission of vibrations to adjacent structures, it is necessary  to provide an air gap around the foundation. Where the elastic under layers such as spring casings are provided below the foundation, the latter should be placed in a reinforced concrete trough and due provision made to give access to  the under lying layers for periodical inspection of replacement.

iii)  In order to reduce the horizontal amplitudes, the height of foundation should be selected as small as possible. A  larger base dimension is selected in the direction of the rock moment if any, acting on the foundation.

iv)  If  several machines are located close-by in the same machine hall, a common foundation may be recommended for all of  the machines, particularly when the underlying soil is soft. However,  the analysis of  vibrations of the foundation for such a group of machines, is complicated. For practical purposes, the common foundation may be considered as broken up to sections corresponding to individual foundations and the computations carried out as if  they were separate foundations. The permissible amplitudes may be increased to 0.25 mm.

 


Related Discussions:- State the planning the foundation for reciprocating engines

Sequecing problm, What is the sequence of this problem Job- 1 2 3 4 5 6 7 ...

What is the sequence of this problem Job- 1 2 3 4 5 6 7 M/c M1 4 13 16 7 11 12 10 M2 9 11 11 7 13 2 4

Back Rake Angle, Why is back rake angle preferred to be negative for brittl...

Why is back rake angle preferred to be negative for brittle materials?

Shock absorbers, how bike''s hydraulic shock absorbers work?

how bike''s hydraulic shock absorbers work?

Dislocation, Diff. B/w edge and screw dislocation

Diff. B/w edge and screw dislocation

Evaluate thickness of leaves, A semi-elliptical laminated vehicle spring to...

A semi-elliptical laminated vehicle spring to took a load of 6000 N is to consist of seven leaves 65 mm wide, two of the leaves extending the full length of the spring. The spring

Fuel consumption is high motorcycle problem, If Fuel Consumption is High ...

If Fuel Consumption is High Causes of Problem Remedy   Incorrect electrode gap of spark plug Worn out electrodes o

Explain the procedure of removal for valves, (a) Explain the procedure of r...

(a) Explain the procedure of removal for valves. (b) How should one remove valve guide from cylinder head? (c) What is the use of piston side base? (d) What is the use of

Determine for water flow rate, A counter flow heat exchanger is used to coo...

A counter flow heat exchanger is used to cool 2000kg/hr of oil(Cp= 2.5 KJ/Kg K) from 105 o C to 30 o C by the use of water entering at 15 o C. If the overall heat transfer coeff

Transformer for flash butt welding, Transformer for flash butt welding ...

Transformer for flash butt welding The transformer required for flash butt welding is similar to that needed for other resistance welding processes. Here, the transformer is to

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd