State the difference between byte streams and message, Computer Networking

Assignment Help:

State the difference between Byte streams and message

Byte streams and message are different. In a message stream, network keeps track of the message boundaries. In a byte stream, it does not keep tracks. For instance, suppose a process writes 1024 bytes to the connection and then a little later writes another 1024 bytes. The receiver then reads 2048 bytes.

With the message stream, receiver will get two messages each of 1024 each. With a byte stream, message boundaries do not count and receiver will get the full 2048 bytes as a single unit. The fact that there were originally two separate messages is lost.

 

 


Related Discussions:- State the difference between byte streams and message

Determine the specification of fddi, FDDI has four specifications: 1. M...

FDDI has four specifications: 1. Media Access Control it defines how the medium is accessed 2. Physical Layer Protocol it defines data encoding/decoding procedures 3. Phy

Packet cost - network layer and routing , Packet  Cost Both  distance ...

Packet  Cost Both  distance vector and link  state  routing  are lowest  algorithms. Tow factors  govern  how  cost is applied to packets  in determines  a route. Cost  is a

At which layer of the osi model repeaters work, At the Physical layer of ...

At the Physical layer of the OSI model Repeaters work by regenerating the signal to extend the distance it can travel.

Link layer process, Each link layer process will have two connections: one ...

Each link layer process will have two connections: one "up" to the appropriate IP layer process, and one "sideways" to the link layer process on the simulated machine at the other

Error detection-general, Q. Error Detection-General? Sender transmi...

Q. Error Detection-General? Sender transmits every data unit twice Receiver performs bit-by-bit comparison between those two versions of data. Any mismatch would

Configure the physical topology- ccna, Configure the Physical Topology ...

Configure the Physical Topology Step 1: Cable the network. Refer to the figure and table below for the essential cables. Step 2: Physically connect lab devices. C

Explain about twisted-pair cable, Q. Explain about Twisted-Pair Cable? ...

Q. Explain about Twisted-Pair Cable? - Two conductors surrounded by insulating material - One wire utilize to carry signals and other used as a ground reference - Twistin

Application of internet control message protocol, The application for this ...

The application for this assignment is somewhat arti?cial. Normally, an application would not interact directly with IP. Instead, it would create a UDP or TCP socket and interact w

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd