State about data and data files - information, Computer Networking

Assignment Help:

State about data and data files - Information

The third and major component of the system liable to be attacked is the data and data files used by the company. It is the most serious of all the threats. Threats to the hardware and software are considered negligible in comparison with the threats to information since it is this information that acts as the knowledge about the organisation. Hardware can be replaced and software can be reinstalled, but information once lost cannot be got back.

 


Related Discussions:- State about data and data files - information

Des key, Assume the following 64-bit DES key (expressed in hexadecimal): FE...

Assume the following 64-bit DES key (expressed in hexadecimal): FEFE FEFE FEFE FEFE (a) What is the term for such a key? (b) State the value of each of the 48-bit round keys

Disadvantages - point to point , Disadvantages You typically  would  no...

Disadvantages You typically  would  not use a packet filter  as your  only security solution for your network  packets filters have two  major  disadvantages. a. Low securit

Find the domain, Find the domain Name of 128.252.160.200

Find the domain Name of 128.252.160.200

Write the purpose of split horizon, Split Horizon - If you attain a protoc...

Split Horizon - If you attain a protocol's route on an interface, do not send information about that route back out that interface.

Example of record route ip option, 1. Suppose the datagram source allocates...

1. Suppose the datagram source allocates 12 bytes for this option. Then when the datagram leaves the source host, the RR option area will be like this: 7 12 4 0 0 0 0 0 0 0 0 0

Network, What are the advantages of logging more information to the alerts ...

What are the advantages of logging more information to the alerts filestion #Minimum 100 words accepted#

How to Assign switch ports to VLAN, Assign switch ports to VLANs. Refe...

Assign switch ports to VLANs. Refer to the port assignment table at the starting of the lab to assign ports to the VLANs. Use the interface range command to make simpler this

Fault tree analysis, FAULT TREE ANALYSIS Reliability engineering, in a ...

FAULT TREE ANALYSIS Reliability engineering, in a nutshell is concerned with failures.   How failures occur, how often they occur, and how to minimize them are the basic proble

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd