Source to destination data transfer - datagram approach, Computer Networking

Assignment Help:

Source to Destination Data Transfer - Datagram approach

1264_Source to Destination Data Transfer - Datagram approach.png

- Each packet is treated independently.

- Every pkt will take its own path to reach the destination.

- There isn't sequence orders are followed.

- The Arrangement of packets will be completed by the Transport layer at destination.

- No necessitate for call setup.

- The packets have source and destination address thus it will reach the destination.

- However there is a possibility the data may lost.


Related Discussions:- Source to destination data transfer - datagram approach

Define co-axial cable, Define Co-axial cable. A solid central conducto...

Define Co-axial cable. A solid central conductor surrounded by insulating material and then by a cylindrical shield woven from fine wires is called as co-axial cable. The shie

How to install an anti-virus program, In a network that contains two server...

In a network that contains two servers and twenty workstations, where is the best place to install an Anti-virus program? An anti-virus program must be installed on all servers

Types of ends in wan, There are two types of ends in WAN (1)DTE (DATA TE...

There are two types of ends in WAN (1)DTE (DATA TERMINAL EQUIPMENT) (2)DCE(DATA COMMUNICATION EQUIPMENT)

Uneven load distribution, Uneven Load Distribution In the parallel com...

Uneven Load Distribution In the parallel computer, the problem is dividing into sub-problems and is assigned for computation to various processors. But sometimes the sub-probl

Calculate bandwidth needed for voice traffic, The second point to consider ...

The second point to consider is that from each location, some calls are internal to that site and some are going to outside locations. Again, as an approximation, MyCo telecom peop

Cisco router architecture, Cisco Router architecture Overall architec...

Cisco Router architecture Overall architecture of Cisco 2600 router is given below The Following components of routers are 1.    WIC slots 2.    communications

Describe ethernet, Describe Ethernet. Ethernet is one of the well-liked...

Describe Ethernet. Ethernet is one of the well-liked networking technologies used these days. It was developed during the early 1970s and is based on specifications as stated i

Causes of failures, CAUSES OF FAILURES Every failure has a well-define...

CAUSES OF FAILURES Every failure has a well-defined cause.  Any system or device has an inherent strength or capacity to resist failures. This depends on design, material, man

Advantages of ospf - network layer and routing , Advantages of OSPF OSP...

Advantages of OSPF OSPF an is having different  advantages. These are as follows. OSPF  is an open standard supported by many  vendors. OSPF converges quickly. OSPF au

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd