Sampled-data and digital control systems, Electrical Engineering

Assignment Help:

Q. Sampled-data and digital control systems?

These differ fromthe continuous-data systems in that the signals at one or more points of the system are in the form of either a pulse train or a digital code. Sampled-data systems usually refer to a more general class of systems whose signals are in the form of pulse data, whereas a digital control system refers to the use of a digital computer or controller in the system. The term discrete-data control system is used to describe both types of systems.


Related Discussions:- Sampled-data and digital control systems

Draw and explain diode clipping circuit, Q. Draw and explain diode clipping...

Q. Draw and explain diode clipping circuit ? A diode clipping circuit can be used to limit the voltage swing of a signal. Clipper circuits are used to clip a portion of the w

A circuit having of a resistor connected in series, A circuit having of a r...

A circuit having of a resistor connected in series with a 0.5µF capacitor and has a time constant of 12 ms. Verify: (a)  The value of the resistor (b)  The capacitor voltage

Briefly explain single mode and multimode fibres, Briefly explain single mo...

Briefly explain single mode and multimode fibres The optical fibres were categorized within two according to the number of modes it passes as: • Single mode fibres • Multi mode

Determine the steady state position error, Figure shows the block diagram o...

Figure shows the block diagram of an aircraft pitch stabilization system which uses position, velocity and acceleration feedback. i) Show that for a unit step input the steady s

What do you mean by communication channel, Q. What do you mean by communica...

Q. What do you mean by communication channel? The communication channel (transmissionmedium) is the physicalmediumthat is utilized to send the signal from the transmitter to th

What do you mean by addressing and numbering, Q. What do you mean by addres...

Q. What do you mean by addressing and numbering? Numbering and Addressing: In data and telephone networks, end equipment are more often single units than multiple devices uni

Bad workmanship, Bad Workmanship Bad workmanship contributes important...

Bad Workmanship Bad workmanship contributes importantly towards increasing distribution losses. Efforts should, thus, be made to have the best probable workmanship. In this co

What do you mean by time consistent busy hour, Q. What do you mean by Time ...

Q. What do you mean by Time consistent Busy Hour? (i) Busy Hour (ii) Peak Busy Hour (iv) Time consistent Busy Hour  (v) Traffic intensity Ans: (i)  Busy Hour: C

What is trans conductance, Q. What is Trans conductance? It is ratio of...

Q. What is Trans conductance? It is ratio of small change in drain current to the corresponding change in the gate-to-source voltage for a constant gate-to-source voltage .it i

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd