Repeatability , Electrical Engineering

Assignment Help:

Reproducibility and repeatability are measures of closeness with which a given input may be measured over again. The two terms cause confusion. Therefore, a distinction is made between the two terms. Reproducibility is specified in terms of scale readings over a given period of time.

On the other hand, repeatability is defined as the variation of scale reading and is random in nature. 

 

 


Related Discussions:- Repeatability

Wireless and communication, With a maximum excess delay of and a chip durat...

With a maximum excess delay of and a chip duration of , the multipath components fall in delay bins. This means that we experience leakage of energy between chips and the channel i

Machine, explain inifinite bus

explain inifinite bus

Calculate the maximum length of an optical fibre, Calculate the maximum len...

Calculate the maximum length of an optical fibre that exhibits 0.8dB/km attenuation if the optical output is 10mW and the power launched at the input is 150mW. [Hint: Loss, L=10 lo

Scr, what is finger voltage?

what is finger voltage?

Ohm, what is ohm?

what is ohm?

Determine the effective input noise temperature, Q Determine the effective ...

Q Determine the effective input noise temperature of a long piece of waveguide (that connects an antenna to a receiver) with a loss of 3.4 dB at 12 GHz and a physical temperature o

What is the minimum sampling rate, Q. The magnitude spectrum of a continuou...

Q. The magnitude spectrum of a continuous  image is as given below.  a) Sketch the frequency response of the sampled spectrum if   ωs =1.5 ωm along x and 3ωm along  y directions

Show the block diagram for a 3-bit ripple counter, Q. (a) For a JKFFwith JK...

Q. (a) For a JKFFwith JK = 11, the output changes on every clock pulse. The change will be coincident with the clock pulse trailing edge and the flip-flop is said to toggle, when T

Show the subtraction method, Q. Show the Subtraction Method? For this p...

Q. Show the Subtraction Method? For this procedure (method), start with a weighted position value greater that the number. If the number is greater than the weighted position f

Write down expressions for vbn, Q. Referring to Figure, let V BN = V RN =...

Q. Referring to Figure, let V BN = V RN = 120 V rms magnitude, and V BR = 240 V rms magnitude. Write down expressions for v BN (t), v RN (t), and v BR (t), and sketch them as a

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd