programming in c and data structure, Electrical Engineering

Assignment Help:
algorithm for Reversing the digits
of an integer

Related Discussions:- programming in c and data structure

FRACTIONAL PID TUING USING GA FOR LOAD FREQUENCY CONTROL, Iam doing my proj...

Iam doing my project on LFC using tuned FOPID.I have considered a two area model..I need help regarding my project.i need help regarding implementation of GA MATLAB code for a two

Sketch the circuit with all the relevant labelling, Question: (a) Consi...

Question: (a) Consider the subsequent LC impedance function: (i) If the function is to be realised using the Foster I Form, evaluate the values of the different compon

Calculate the induced voltage, Q. A four-pole, lap-wound armature has 144 s...

Q. A four-pole, lap-wound armature has 144 slots with two coil sides per slot, each coil having two turns. If the flux per pole is 20 mWb and the armature rotates at 720 r/min, cal

Mov instruction, MOV Instruction Op code  format  of MOV  instruction i...

MOV Instruction Op code  format  of MOV  instruction is as follows : Replace the  codes of destination register and source  register with code of  required  register from.

Control, Ask The goal of this project is to model a system and to design a ...

Ask The goal of this project is to model a system and to design a controller for the system so that the closed-loop system performs satisfactorily. We want to accurately positio

Signals and spectral analysis, Q. Signals and spectral analysis? Figure...

Q. Signals and spectral analysis? Figure shows the functional block diagram of a signal-processing system. The information source may be a speech (voice), an image (picture), o

Block schematic diagram of ss7, Q. Block schematic diagram of SS7? Leve...

Q. Block schematic diagram of SS7? Levels are as below: Level 1: The Physical Layer Level 2: The Data Link Level Level 3: The signaling network level Level 4: The User Pa

Tvm, Why is the signal first attenuated and then amplified?

Why is the signal first attenuated and then amplified?

Give the classification of oscillators, Q. Give the classification of Oscil...

Q. Give the classification of Oscillators?  Depending on the type of the output waveform, oscillators are classified as sinusoidal (or harmonic) oscillators and relaxation osci

Explain loop instructions in 8086 family, Explain LOOP instructions in 80...

Explain LOOP instructions in 8086 family with example and their effect on flag. LOOP: (Jump to given label until CX = 0) it is used to repeat a sequence of instructions for

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd