Product Design and Development, Mechanical Engineering

Assignment Help:

I need a work to be done in the field of technical function generation for a product development process and about 3000-3500 words on any theoretical topic related to product development process.

Related Discussions:- Product Design and Development

Thermodynamic properties , Q= In an investigation of the thermodynamic prop...

Q= In an investigation of the thermodynamic properties of alpha-manganese,the following heat contents determined H 700 - H 298 = 2895 cal/g-atm H 1000 - H 298 = 5450 cal

Nature of distribution of bending stress, Natur e of Distribution of Bendi...

Natur e of Distribution of Bending Stress Figure Nature of stress distribution in section of a beam It will be proved that bending stress at any layer of section o

Define the project scope, Q. Define the project scope? The Design Basis...

Q. Define the project scope? The Design Basis Memorandum defines the project scope. This includes basic design concepts and the basis and philosophies upon which the project s

Calculate additional force required to maintain equilibrium, Calculate Addi...

Calculate Additional force required to maintain equilibrium: Fo r the system shown in figure find the additional single force required to maintain equilibrium. Sol.: L

Limitations of resistance welding, Limitations of resistance welding ...

Limitations of resistance welding 1). Pressure - tight joints are achieved only with flash butt welding. Resistance welding is not recommended for high pressure joints a

Direct current, Direct Current ( DC ) : The direct current flows through...

Direct Current ( DC ) : The direct current flows through a wire in one direction and it remains same over time. The current from battery is always direct current. Direc

Maximum shear stress, An aircraft flap actuator housing made of cast magnes...

An aircraft flap actuator housing made of cast magnesium alloy ZAG3A-T4 with uniaxial yield strength σ Y = 14,000 psi. At the suspected critical point the calculated state of str

Volume fraction of fibres, Volume fraction of fibres: The epoxy materi...

Volume fraction of fibres: The epoxy material is prepared to be stressed to its full strength. What must be volume fraction of fibres? Solution Here σ′ = 1200 MPa,

Wind induced vibration of vertical vessels, Q. Wind Induced Vibration of Ve...

Q. Wind Induced Vibration of Vertical Vessels? Vertical vessels having a height-to-diameter ratio (h/D) (does not include insulation thickness but does include skirt height) gr

Determine the chemical formulate for refrigerant, (a) Draw P-H and T-S diag...

(a) Draw P-H and T-S diagrams for following cases : (3) (i) Cycle with superheated vapour before compression. (ii) Cycle with sub-cooling or under-cooling of refrigerant.

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages