Compressive strain, Compressiv e Strain: When the compressive load ac...

Compressiv e Strain: When the compressive load acts on body then there will be an increase in cross sectional area and decrease in length of body. The ratio of reduction in l

Define corrosion-resistant nickel-based alloys, Q. Define corrosion-resista...

Q. Define corrosion-resistant nickel-based alloys? The corrosion-resistant nickel-based alloys offer a significant improvement in corrosion resistance to sulphuric acid over th

Safety and loss prevention, Q. Safety and Loss Prevention? Are there sp...

Q. Safety and Loss Prevention? Are there special venting requirements for flammables and toxic materials? Air conditioning, heating and ventilation: • are non-sparking fa

Determine the need for insulation, Q. Determine the need for insulation? ...

Q. Determine the need for insulation? Equipment and piping shall be insulated as required for heat conservation, process heat control and personnel protection. The temperatu

Poisionsratio,

co2 welding, CO2 Welding CO2 Welding is a variation of GMAW. Here the ...

CO2 Welding CO2 Welding is a variation of GMAW. Here the inert gas is replaced by gas mixtures or carbon dioxide, which are chemically active. The carbon dioxide decomposes in

Extent of the hazardous zone, The extent of a hazardous area depends on the...

The extent of a hazardous area depends on the rate of release, ventilation conditions, and fluid properties and is defined by the relevant regional or country standards. The pot

Evaluate power transmitted by shaft, Evaluate power transmitted by shaft: ...

Evaluate power transmitted by shaft: How do you evaluate power transmitted by shaft (P)? Sol.: Consider force 'F' Newton's acting tangentially on shaft of radius ' R '.

Environmental factors for high temperature service materials, Q. Environmen...

Q. Environmental factors for high temperature service materials? Many environmental factors must also be considered when choosing a material for high temperature service. High

Find out stress - strain and elongation of bar, Find out stress - strain an...

Find out stress - strain and elongation of bar: A circular rod having diameter 20 m and 500 m long is subjected to the tensile force of 45kN. The modulus of elasticity for st