opportunity cost, Mechanical Engineering

Assignment Help:
whats the example of opportunity cost?

Related Discussions:- opportunity cost

Determine the work done, Determine the work done per minute by a punch tool...

Determine the work done per minute by a punch tool making 20 working strokes min when a 30 mm diameter hole is punched in 5 mm thick plate with ultimate shear strength of 450 MPa i

Explain about burner management system, Q. Explain about Burner Management ...

Q. Explain about Burner Management System? The Vendor shall provide a stand alone Burner Management System that is NFPA approved. Provision shall be made for communication wit

Common rules concerning corresponding option , COMMON RULES CONCERNING CORR...

COMMON RULES CONCERNING CORRESPONDING OPTION:     Let us consider the DATA DIVISION entries as shown below. Now, let us see which data items will be moved if

Illustrate centrifugal tension of belt drive, Illustrate the following term...

Illustrate the following terms:- a) Mechanism and Inversion b) Slip and Creep of belt drive c) Centrifugal Tension of belt drive d) Initial Tension of belt drive

Assumptions in analysis of simple truss, Assumptions in analysis of simple ...

Assumptions in analysis of simple truss: What are assumptions made in analysis of simple truss? Sol.: The assumptions made in finding out forces in the frame are, (1)

Aerospace engineering, Have you ever been sit on a flight? Have you ever th...

Have you ever been sit on a flight? Have you ever think how those gigantic machines are developed ? Aerospace engineering is just the place where you require to be. Aerospace engin

Calculation of seismic response loads, Q. Calculation of seismic response l...

Q. Calculation of seismic response loads? The seismic design requirements and the specification of criteria variables for the calculation of seismic response loads for the desi

Postweld heat treatment, Q. Postweld heat treatment? When the equipment...

Q. Postweld heat treatment? When the equipment data sheet specifies post-weld heat treatment either for service conditions or code requirements, welding, hammering (peening), o

Residual stress and deformation in aluminum, deformation and stress in alum...

deformation and stress in aluminum 6061 after extrusion

Spanners tool and equipment , Spanners: These are used to tighten and loos...

Spanners: These are used to tighten and loosen nuts and bolts. These are made according to standard nut and bolt sizes and in vanadium steels. The following types of spanner are u

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd