Objectives of param algorithem, Computer Networking

Assignment Help:

After going through this part, you should be capable to:

Describe the concepts of message passing programming;
List out the various communication modes for communication among processors;
Describe the concepts of shared programming model;
Explain and use the functions defined in MPI;
Recognized and use functions defined in PVM;
Describe the concepts of data parallel programming, and
Study about different data structures like array, linked list and hypercube.

Related Discussions:- Objectives of param algorithem

Explain about traditional modems, Q. Explain about Traditional Modems? ...

Q. Explain about Traditional Modems? - Subsequent to modulation by the modem an analog signal reaches the telephone company switching station where it sampled and digitized to

Fiber distributed data interface, Question 1 Write short notes on (i) F...

Question 1 Write short notes on (i) Fiber Distributed Data Interface (ii) Serial Line Question 2 Explain Internet layer and transport layer Internet layer Tran

Configure the logical topology- ccna, Configure the Logical Topology S...

Configure the Logical Topology Step: Configure the host computers. Configure the static IP address, subnet mask, and gateway for every host computer. Note: The followi

Determine the maximum value for vout, Approximately what is the maximum val...

Approximately what is the maximum value for Vout?

What is single-mode fiber, What is Single-mode fiber Single-mode fiber ...

What is Single-mode fiber Single-mode fiber is competent of higher bandwidth and greater cable run distances than multi-mode fiber. For the reason that of these characterist

Packet switching, Suppose there are exactly five packet switches (Figure 4)...

Suppose there are exactly five packet switches (Figure 4) between a sending host and a receiving host connected by a virtual circuit line (shown as dotted line in figure 4). The tr

Compute the number of lost packets of the down-stream, A mobile host (MH) i...

A mobile host (MH) is connected to a WLAN access network that uses MIP for mobility support. Consider that the RTTs between MH and HA are 0.3s while RTTs within a L2 subnet are 80

What is the administrative distance for igrp, IGRP is a distance vector rou...

IGRP is a distance vector routing protocol designed by Cisco. The maximum hop count is 255, and it uses a combination of variables to verify a composite metric. IGRP has an adminis

Calculate the voltage on the capacitor, Quetion: A 22 nF capacitor is i...

Quetion: A 22 nF capacitor is initially charged to 10V. It is then discharged by connecting a 100kW resistor across it. Approximately how long does it take for the voltage on t

How is nat implemented, How is NAT executed

How is NAT executed

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages