Monte Calro for aerodynamic load simulation.., Mechanical Engineering

Assignment Help:

I have experimental results for a 2D model and a matlab script that computes the aerodynamic loads on that 2D model.When we compare experiment with the theory I have noted that the theory cannot capture some physical variation seen in experiment. Can we perform analysis via Monte Carlo method to capture these variation?
Thanks

Related Discussions:- Monte Calro for aerodynamic load simulation..

Joule''s law and enthalpy - thermodynamics, Joule's Law and Enthalpy - Ther...

Joule's Law and Enthalpy - Thermodynamics: Joule ' s Law Joules law experiment is based on the constant volume process, and it state that I.E. of perfect gas is a fun

Evaluate the sliding velocity, Two mating spur gear with module pitch of 6....

Two mating spur gear with module pitch of 6.5 mm have 19 and 47 teeth of 20 degree pressure angle, and 6.5 mm addendum. Evaluate the number of pairs of teeth in contact and the ang

Modelling and simulation study, A city owns and operates a garage in which ...

A city owns and operates a garage in which maintenance and repair work is performed on city-owned vehicles. Included among these vehicles are motor-pool cars, heavy-duty trucks, an

Principle stresses, Determine the bending (o-, ) and shear stress ( Tx), )...

Determine the bending (o-, ) and shear stress ( Tx), ) at the surface element shown on the solid circular shaft below. Use Mohr's circle to determine the principle stresses, a l

Three forces act on particle - mechanics, Three forces act on particle: ...

Three forces act on particle: Thr ee forces act on particle ' O ' as shown in the figure given below. Determine the value of ' P ' such that resultant of these three forces

Hydropower scheme, 4. Design a run-of-the river hydropower scheme for a riv...

4. Design a run-of-the river hydropower scheme for a river in the Scottish Borders with potential level different of 15 m carrying water from a catchment area of 14 km by 25 km. I

Refrigerationequipments, refrigerationequipmentsandfigures

refrigerationequipmentsandfigures

Determine the location of the hydraulic jumps - water depths, Problem: In H...

Problem: In HEC-RAS, model this system as 1 reach with cross-sections every 2 ft. For all 3 discharges (labeled as: design, low, flood), (a) Determine the water depths 10 ft fro

Determine the natural circular frequencies, The two-storey frame shown in ...

The two-storey frame shown in Figure Q4 is such that the self-mass may be considered to be located at the beam levels and the beams may be presumed to be rigid. The self-mass (

Symmetric central force, Symmetric Central Force A central force is sph...

Symmetric Central Force A central force is spherically if the magnitude of the force does not depend on the direction (angles θ , or Ø ) of the particle but only on distance

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages