Mobile Communication, Other Engineering

Assignment Help:
A car, moving in the south-east direction at a velocity of 5 m/s, receives a ray of power of -120 dBm each from the north, east and west. The carrier frequency is 300 MHz.
(i) Sketch the Doppler spectrum for this channel.
(ii) What are the Doppler bandwidth and the coherence time?

Related Discussions:- Mobile Communication

Homework, name the functions of the CIPM

name the functions of the CIPM

Radar engineering, Calculate the maximum range when radar operates at 10GHz...

Calculate the maximum range when radar operates at 10GHz and has peak power=10 Mwatt,S/N ratio=10dB,antenna cross section=100 mm2,target cross section=10mm2.The gain of transmittin

Magnetic detector plug debris analysis of aircraft , Magnetic Detector Plug...

Magnetic Detector Plug Debris Analysis of aircraft : The magnetic chip detectors (MCDs), are small, permanent magnets installed in the scavenge/return lines of the engine oil s

Installing aircraft parts, Installing Aircraft Parts: Prior to fit remo...

Installing Aircraft Parts: Prior to fit remove the label from the engine and attach it to the paperwork for safekeeping. Check the engine over to ensure it is complete and chec

Bio physiology Matlab Simulink Models, Review the lecture on BB document “P...

Review the lecture on BB document “Pharmacology …..” slide 6 where the solution for a 1st order system was demonstrated. The generic system is A(X)?(K1)?B(Y)?(K1’)?C(Z) 1. Cr

Oil pumps - aircraft engine, OIL PUMPS The oil pumps fitted in a recirc...

OIL PUMPS The oil pumps fitted in a recirculatory system are normally gear-type or Gerotor type pumps. The pumps are usually mounted in a pack containing one pressure pump and

Hydraulics.., A pump delivers 40 lpm to a 100 mm bore/25 mm rod cylinder to...

A pump delivers 40 lpm to a 100 mm bore/25 mm rod cylinder to move a load of 22 kN. A throttle is introduced on the rod end, and return flow with a 10 lpm flow rate. A 70 bar press

Heat and mass transfer, 1. Air at 1 atm, 90F, and 8 ft/s enters a thin-wall...

1. Air at 1 atm, 90F, and 8 ft/s enters a thin-walled tube of 4-in diameter. The tube surface temperature is maintained at 60F. Air exits the tube at 70F. Determine the length of t

Heat treatment of cast iron, how does a cast iron cooling curve look,effect...

how does a cast iron cooling curve look,effect of heating temp, duration also cooling rate

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd