microprocessor, Electrical Engineering

Assignment Help:
if (n<10)
n=n+1
else
n=n-1
n=0

how to write this command

Related Discussions:- microprocessor

Indicate the condition of the overflow and carry bits, Q. Do the following ...

Q. Do the following operations with 8 bit bytes, and indicate the condition of the overflow and carry bits. a) 10111011 + 00000011 b) 11101101 + 11111001 c) 11011011 + 110

#DSP ., #The requirement is as follows- There is a signal which is in the r...

#The requirement is as follows- There is a signal which is in the range of 0 to 5Hz. This signal frequency composition is to determined. The resolution of the determination is 1Hz.

Dissemination of Learning - KPI, Dissemination of Learning - KPI Manag...

Dissemination of Learning - KPI Management has initiated a program, consequently invested a considerable amount of resources and learnt a lesson too. This learning now needs t

MECHANICAL SCIENCE, 0PERATION OF POWER TRANSMISSION (SPEED GOVERNORS)

0PERATION OF POWER TRANSMISSION (SPEED GOVERNORS)

Integrator with positive voltage on a noninverting input, Q. An integrator ...

Q. An integrator with positive voltage on a noninverting input is shown in Figure. Sketch v o for 60 ms after S has been opened.

Optoelectronic, Need a project in Optoelectronic with simulation in Optispi...

Need a project in Optoelectronic with simulation in Optispice or Matlab.with complete report and presentation. ANy ideat about project and how much does it cost.

Hall effect experiment, Hall Effect experiment: Prob. Write short not...

Hall Effect experiment: Prob. Write short note on Hall Effect and its applications. What properties of a semiconductor are determined from a Hall Effect experiment? Sol.

What is the significance of source gate cutoff voltage, Q. What is the sign...

Q. What is the significance of source gate cutoff voltage? The source gate cutoff voltage is also called pinch off voltage. It is obtained when VDS increases and approaches a l

State the functions of a fuse, State the functions of a fuse. Fuse is ...

State the functions of a fuse. Fuse is a protective device that made of a thin wire or strip. This strip or wire is placed with the circuit this has to protect, therefore the

What is the need of modem in data communication, Q. What is the need of MOD...

Q. What is the need of MODEM in data communication? Need of Modem: Modems are used to interface computers, computer networks in addition to other terminal equipment to teleco

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd