microcontroller, Electrical Engineering

Assignment Help:
What are usue and all the details of 8051 microcontroller with its block diagram pin diagram and all other details

Related Discussions:- microcontroller

Determine the peak magnetizing current, A forward converter has the followi...

A forward converter has the following parameters: input source voltage V s = 100 V, N 1 /N 2 = N 1 /N 3 = 1, magnetizing inductance L m = 5 mH, output inductor L o = 200 μH, C

Critical rate of rise of current - thyristor , Critical Rate of  Rise of ...

Critical Rate of  Rise of Current The maximum  rate of  increase of current  during  on state  which  the SCR  can tolerate is called  the critical rate of rise  of current  f

Calculate maximum reactive power the generator can produce, A 3-phase, wye-...

A 3-phase, wye-connected, 11.8 kV, 100 MVA turbo- generator of 0.8 power factor lagging has a synchronous reactance of 2.0 p.u. on rating. The generator is driven by a steam turbin

Working principle of a d.c. generator, Q.  Explain the working principle o...

Q.  Explain the working principle of a d.c. generator. Explain clearly the function of commutator in d.c. machines. Sol. Working principle of a D.C. generator: For the 2- po

Paper on Matrix Computer Methods, 5 page paper on matrix and computer metho...

5 page paper on matrix and computer methods applied to Linear Gear trains

Develop a general expression for the force, Consider an electromagnet, as s...

Consider an electromagnet, as shown in Figure, which is used to support a solid piece of steel and is excited by a coil of N = 1000 turns carrying a current i = 1.5 A. The cross-se

Determine the shaft power output, Determine the shaft power output: A ...

Determine the shaft power output: A 6-pole, 50 Hz, 3-phase induction motor running on full load develops a useful torque of 180 Nm when the rotor emf frequency is 2 Hz. Determ

Dc simulation component, Once you are happy with the biasing components you...

Once you are happy with the biasing components you will need to disable the DC simulation component and enable the SP component. (Right click the component and then select the "com

Voltage, Voltage, current, and charge control: The collector-emitter c...

Voltage, current, and charge control: The collector-emitter current can be seen as being controlled through the base-emitter current (current control), or through the base-emi

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd