mechanics of solids, Civil Engineering

Assignment Help:
Ask question #MinThe maximum instantaneous extension, produced by an unknown falling weight
through a height of 4 cm in a vertical bar of length 3 m and of cross sectional
area 5 cm2, is 2.1 mm. Determine (a) the instantaneous stress induced in the
vertical bar, and(b)the value of unknown weight. Take E=2×105 N/mm2imum 100 words accepted#

Related Discussions:- mechanics of solids

Show the settlement due to vibration, Q. Show the Settlement due to Vibrati...

Q. Show the Settlement due to Vibration? The foundation resting on cohesionless soil and subjected to vibrations will result in settlements of higher magnitude. In sandy soil

Define hydraulic tools for underwater inspection of bridge, Define Hydrauli...

Define Hydraulic tools for underwater inspection of bridge? Hydraulic tools involve grinders, rotary brushes and scrubbers. The benefits of hydraulic tools are the same as thos

Determine the daylight factor of a room, QUESTION (a) What is the def...

QUESTION (a) What is the definition of Day light Factor (D)? (b) Determine the daylight factor of a room of an area of 100m 2 with an opening of 50m 2 of glazing. As wha

Determine the maximum pressure at the base of the wall, A masonry retaining...

A masonry retaining wall of trapezoidal section with the vertical face on the earth side is 1.5 m wide at the top and 3.5 m wide at the base and is 5.0 m high. It retains a sand fi

State the ultimate load capacity of the pile group, A group of 16 piles of ...

A group of 16 piles of 50 cm diameter is arranged with a centre to centre spacing of 1.0 m. The piles are 9 m long and are embedded in soft clay with cohesion 30 kN/m 2 . Bearing r

Steel structures, how does battening differ from lacing?

how does battening differ from lacing?

Derive, Derived condition of economic span of bridge

Derived condition of economic span of bridge

Cone, if the diameter of the base remains constant by what factor should th...

if the diameter of the base remains constant by what factor should the altitude be multiplied to produce a cone with twice volume as the original

Smallest size of a325 bolts needed for two plates in tension, What is the s...

What is the smallest size of A325 bolts required for the two plates in tension noted below, assuming the thickness of each plate is 1.0-in. and the applied force at each end is P=2

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd