Mechanical characteristics of RS232 interface, Computer Networking

Assignment Help:

Q. Mechanical Characteristics of RS232 interface?

- 9-pin connector

- 9-pin connector is more usually found in IBM-PC but it covers signals for asynchronous serial communication only

- Utilize male connector on DTE and female connector on DCE

- N.B.: all signal names are out looked from DTE


Related Discussions:- Mechanical characteristics of RS232 interface

Floating point representation in memory, Floating Point Representation in M...

Floating Point Representation in Memory 1. Describe the various ways of floating point representation in memory. What is the importance of normalizing the mantissa in this rep

Calculate the peak-to-peak voltage of the signal, A multimeter is used to m...

A multimeter is used to measure a sinusoidal signal and reads 2V RMS; what is the peak-to-peak voltage of the signal? A mark will be deducted if you do not quote your answer to 2 s

Networking assignment, Suppose a small company wants to develop a computer ...

Suppose a small company wants to develop a computer network of 18 computers in its main office. Due to limited resources the company wants a network architecture where a single com

What is the function of the osi session layer, What is the function of the ...

What is the function of the OSI Session Layer? This layer gives the protocols and means for two devices on the network to communicate with each other by holding a session.  Thi

Data sources in circuit-switching mode of operation, A data link is shared ...

A data link is shared by 20 data sources. Each source is active only 10% of the time and produces 1Mbps data rate when active. The sources start their transmissions at random. a

Explain physical layer of osi reference model, Q. Explain physical layer of...

Q. Explain physical layer of Osi reference model? - The physical layer deals among the physical characteristics of the transmission medium. - It defines the mechanical, elec

Give examples of icmp, Ping and Traceroute are used by ICMP for Testing. ...

Ping and Traceroute are used by ICMP for Testing. Destination Unreachable messages are obtained by a router when it does not have a route to the network.

Describe about the term- network, Describe about the term- network If n...

Describe about the term- network If network tends to lose the packets, it is better to acknowledge each one of them separately, so the lost packets could be retransmitted. On t

Networking project for 20 computers, can i get a sample networking project ...

can i get a sample networking project for 20 computer with all network components?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd