Lt metering or low tension metering, Electrical Engineering

Assignment Help:

LT Metering or Low Tension Metering

The subsequent types of meters are generally used for LT consumers:

Whole Current Meters

i)   Single phase meters

ii)   3-phase 4 wire meters

iii)  3-phase 3 wire meters

CT Operated Meters

iv)  3-phase 4 wire meters with CT and MD

v)   3-phase 3 wire meters with CT and MD


Related Discussions:- Lt metering or low tension metering

Senior Design Robotic Arm Project, This is basically a simple senior design...

This is basically a simple senior design project where the professors are giving us a limited budget and providing us with an Arduino Board. (We can use rasberry pi, beagle bone, e

What are synchronous decade counters, What are Synchronous Decade Counters?...

What are Synchronous Decade Counters? Alike to an asynchronous decade counter, the synchronous decade counter counts from 0 to 9 and then recycles to 0 again, This is done by

Instrumentation, explain measurement of frqueny and phase using cro

explain measurement of frqueny and phase using cro

Circuit board packaging, Topics for the projects 1. Power supply design:...

Topics for the projects 1. Power supply design: One source, multiple source. Project process: 1.  Design(circuit analysis, diagram, list of components). 2.   Hardware e

Signal in hart protocol, What is the significance of "4-20 mA" signal in ha...

What is the significance of "4-20 mA" signal in hart protocol? Ans) the HART protocol is an old Frequency Shift Keying way of distribution data, typically from highway sensors.

What are transmission bridges, Q. What are transmission bridges? How do the...

Q. What are transmission bridges? How do they assist in satisfying the connectivity?  Ans: A typical transmission bridge is demonstrated in figure. Series capacitance and shunt

Determine the dielectric constant of slab, Determine the Dielectric constan...

Determine the Dielectric constant of slab: An air capacitor contains two parallel plates 10 cm 2 in area and 0.5 cm apart. While a dielectric slab of area 10 cm2 and thicknes

Electronics, why inductive load is use in electronics circuit?

why inductive load is use in electronics circuit?

Discuss mode - 2 of programmable peripheral interface, Discuss mode -2 (bi-...

Discuss mode -2 (bi-directional mode) of 8255 (Programmable Peripheral Interface). Only permitted with port A. Bi-directional bus data used for interfacing two computers and GP

Electronic instrumentation and measurements, why is a delay line used in th...

why is a delay line used in the vertical selection of oscilloscope?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd