Illustrate the term directional solidification, Mechanical Engineering

Assignment Help:

Describe some special kind of patterns and indicate the production circumstances in which each would be need.

Illustrate the term Directional solidification as applied in casting. Why directional solidification is essential and how it helps in production of sound casting ?

What is the purpose of a core ? Explain the method of core making.


Related Discussions:- Illustrate the term directional solidification

What is warm extrusion, Q. What is Warm extrusion? • Warm extrusion is ...

Q. What is Warm extrusion? • Warm extrusion is done above room temperature, but below the recrystallization temperature of the material the temperatures ranges from 424 to 975

What will happen if air filter is not used?, (a) What will happen if air fi...

(a) What will happen if air filter is not used? (b) What are the components of an air filter? (c) What precautions should be followed while cleaning the air filter? (d) What grade

Describe electron beam welding, Discuss any three of the following:- (i)...

Discuss any three of the following:- (i) Electron Beam Welding (ii) Friction Welding (iii) Thermit Welding (iv) Gas Welding Give their advantages, Limitations, and a

What is tantalum, Q. What is Tantalum? Tantalum is one of the most corr...

Q. What is Tantalum? Tantalum is one of the most corrosion-resistant metals known. However, the high cost of tantalum has limited its commercial use as an all-purpose corrosio

Determine fraction of the load would cnt fibers carry, Carbon nanotubes (CN...

Carbon nanotubes (CNTs) with low weight (density = 1.3 g/ cm^3), high tensile strength (50 GPa), and modulus of elasticity (1 TPa) in the axial direction have been touted as the st

Robotics., classify and also explain robot anatomy

classify and also explain robot anatomy

Piston area-engine terminology , Piston Area : The area of a circle of di...

Piston Area : The area of a circle of diameter equal to the cylinder bore is called the piston area and is designated by the letter A and is usually expressed in square centimetr

Design study, how to produce a design that meets the specification given: B...

how to produce a design that meets the specification given: Beam Dimensions W, H and T, where H=2W and T=W/20 • Bolt Size D1 • Side Plate thickness T2 and width W2 • Cradle Plat

Motion of two bodies - smooth surface and smooth pulley, Motion of two bodi...

Motion of two bodies - Smooth surface and smooth pulley: THE HORIZONTAL SURFACE IS SMOOTH AND STRING IS PASSING OVER SMOOTH PULLEY: Figure shows two weights W 1 and W 2 c

What do you mean by filler metals, Q. What do you mean by Filler metals? ...

Q. What do you mean by Filler metals? Use filler metal that is similar in chemistry, corrosion resistance, and mechanical properties of the base metal being welded. Filler m

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd