Illustrate concept of filter design, Civil Engineering

Assignment Help:

Q. Illustrate Concept of filter design?

The material used for filter should satisfy the following normal criteria

a. Filter material is more pervious than the base material / core material

b. Filter material has such gradation that the particles of base / core material do not migrate through. Such migration can clog the voids and fail the very purpose of a filter.

c. Filter material helps to form natural graded material in the zone of base material / core material.

d. Normally, natural material to satisfy the above requirements is not readily available in nature. A graded filter design consists of layers of different grades.

e. To minimise segregation, each grade of the filter material is normally very uniform in size.


Related Discussions:- Illustrate concept of filter design

Career, does felid scope in civil eng. if we start consiltancy job

does felid scope in civil eng. if we start consiltancy job

Hydrographic data for design of bridge, Q.What Hydrographic data required f...

Q.What Hydrographic data required for Design of bridge? (i) Design discharge for bridge waterway and foundation with corresponding high flood levels. Frequency curve for annual

What do you understand by percolation of water, Q. What do you understand b...

Q. What do you understand by Percolation of water? Percolation of water into the ground or embankment takes place, causing rise in water table and / or saturation of the body.

Knife edge loads – representation of wheel axles, Q. Knife edge loads – rep...

Q. Knife edge loads – representation of wheel axles? In BS5400 traffic loads for HA loading are given by uniformly distributed loads along loaded length and a knife edge load.

Explain total dynamic head (tdh), Total Dynamic Head: (TDH) y-axis plo...

Total Dynamic Head: (TDH) y-axis plot point related to each x-axis flow rate along the system curve plot. TDH = h a = TSH + h f + v 2 /2g       v 2 / 2g usually small

Piers and piles, what is the difference between piers and piles?

what is the difference between piers and piles?

State the net allowable bearing pressure, A footing, 2 m square, is founded...

A footing, 2 m square, is founded at a depth of 1.5 m in a sand deposit, for which the corrected value of N is 27. The water table is at a depth of 2 m from the surface. Verify the

Torpedo splice triple wedges, Torpedo splice triple wedges In a Torpedo...

Torpedo splice triple wedges In a Torpedo splice triple wedges, shown in Figure, are provided to firmly hold tendon wires. Whole assembly of the splice is housed in a sleeve. L

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd