Illustrate application specific instruction set processor, Electrical Engineering

Assignment Help:

Illustrate about the term application specific instruction set processor.

Application Specific Instruction-Set Processor (ASIP):

a. Microcontroller: as Intel, Hitachi, Motorola, TI, ARM and Philips, for instance, an Intel® MCS51, Philips®51XA, 51MX, or Motorola: 68HC12, 68HC16 and 68HC11

b. DSP or Typically a Texas tools- C28xSeries, C64xx or C54xx or Analog Devices SHARC or Motorola 5600xx or Tiger SHARC

c. Media processor TI DSP TMS320DM310 or Trimedia Phillips Media Processor 1x00series for Processing Streaming as well as Data Networks and picture, Video-audio and Speech: PNX 1300, PNX 1500(2002)

d. IO processor or

e. Network processor or

f. A domain exact processor


Related Discussions:- Illustrate application specific instruction set processor

Multiplexing 64-to-1 by using four 16-to-1 multiplexers, Q. Show an arrange...

Q. Show an arrangement for multiplexing 64-to-1 by using four 16-to-1 multiplexers and one 4-to-1 multiplexer.

Evaluate circular aperture of receiving antenna, Q. A satellite radio trans...

Q. A satellite radio transmitter has P in = 3 W and G t = 30 dB. The receiving antenna has a circular aperture with radius r at the ground station 30,000 km away. Find r in meter

Produce a storage scope using peripheral interface control, First section ...

First section Aim: the aim of this project is to produce a storage scope using a PIC. In this project, several samples were taken from an analog signal and stored in the memo

Draw an electrical relay diagram, Draw an electrical relay diagram rung sho...

Draw an electrical relay diagram rung showing a N/O contact of CR1(coil) in series witha N/C contact of CR2(Coil), operating a lamp L1. A delay-on (TON) relay has a preset of 5.

Determine harmonic factor hf of the input current, Q. Consider a full-wave ...

Q. Consider a full-wave single-phase bridge recti?er circuit with dc motor load, as shown in Figure (a). Let the transformer turns ratio be unity. Let the load be such that the

Mode 2 - boost converter, Mode 2 In this  mode transistor  gets turne...

Mode 2 In this  mode transistor  gets turned off by  the negative output  of PWM  current  flows  through  inductance L diode D then  divide into two  parts one flows through

Introduction to electronics, Explain the difference between a microprocesso...

Explain the difference between a microprocessor and an embedded microcontroller

LED, PRINCIPLE OF LED

PRINCIPLE OF LED

Current and voltage polarity, why Direct current flow through semiconductor...

why Direct current flow through semiconductors but alternating current cannot flow?

Connection of shunt capacitors at distribution transformer, Connection of ...

Connection of Shunt Capacitors at  Distribution Transformer Provision of capacitors at load point is found to be hard in practice because of the additional investments needed.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd