Illustrate about the digital televisions, Electrical Engineering

Assignment Help:

Illustrate about the Digital televisions

Microprocessor would be used to control the below features, for instance:

- Automatically tuning into television stations

- allow digital signals to be decoded

- Since constantly monitoring signal strength (etc.) far better sound and picture quality result)

-  allows interface with numerous devices

-  In built diagnostics in case of faults

-  Controls picture and sound quality (factory settings can be stored, etc.)  

 


Related Discussions:- Illustrate about the digital televisions

What is piconet, A collection of devices connected by Bluetooth technology ...

A collection of devices connected by Bluetooth technology in an ad hoc fashion.

Binary to hexadecimal conversion, Binary  to Hexadecimal  Conversion ...

Binary  to Hexadecimal  Conversion To convert a binary  number  into  hexadecimal  divide the number into group  of four  bits  each starting from the least significant bit. Th

Serial input output ports , Serial Input output Ports For serial  inpu...

Serial Input output Ports For serial  input  and output  there are  two pins  in 8085 microprocessor

Microprocessor system, A burglar alarm system is controlled by a microproce...

A burglar alarm system is controlled by a microprocessor system. The system has three independent circuit each consisting of 7 passive infra red sensors. The controller can be prog

Explain about dial pulses, Q. Explain about Dial Pulses? Dial pulsing (...

Q. Explain about Dial Pulses? Dial pulsing (sometimes known as rotary dial pulsing) is the method basically used to transfer digits from a telephone set to the local switch. Pu

How can a jfet be used as a constant current source, Q. How can a JFET be u...

Q. How can a JFET be used as a constant current source? Explain from the drain characteristics. As the VDS voltage is increased from 0 to a few volts, the current will increase

Improving joints and connections - energy loss, Improving Joints and Connec...

Improving Joints and Connections - Energy Loss Improper joints are a source of energy loss in both overhead and underground systems. The conductivity of joint should not be le

Determine the capacitor and inductor voltages, Experiment • Wire the circu...

Experiment • Wire the circuit shown in Figure. Connect the three oscilloscope channels as shown in Figure. • Select the sinusoidal waveform. Adjust the frequency of the input volt

Which alloy is used for making heater & thermocouple element, Give the name...

Give the names of four alloys along with their composition, which are used for making heater and thermocouple elements. Constantan or Eureka {(55 to 60 percent) Cu, (45 to 40 p

Find the current through each resistor, For the circuit in figure, find the...

For the circuit in figure, find the current through each resistor.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd