I want some Atmel c code converted to work with the Arduino UNO. It is a maximum power point tracking routine.

It will need to be well noted so that i can change it later. If the end result works well there might also be more work available for a later project.

The PWM output will be on any pin and should be at around 20 khz

The current input can be a 0-5 volt signal and will be on any input pin

The voltage input can be a 0-5 volt signal and will be on any input pin

The software should be efficient

I would also like to include a variable resistor to limit the output at a certain voltage.

I have a buck converter board that can be used to test the software.

Skills required are Arduino, Electrical Engineering, C Programming, Electronics, Microcontroller

I want some Atmel c code converted to work with the Arduino UNO. It is a maximum power point tracking routine.

It will need to be well noted so that i can change it later. If the end result works well there might also be more work available for a later project.

The PWM output will be on any pin and should be at around 20 khz

The current input can be a 0-5 volt signal and will be on any input pin

The voltage input can be a 0-5 volt signal and will be on any input pin

The software should be efficient

I would also like to include a variable resistor to limit the output at a certain voltage.

I have a buck converter board that can be used to test the software.

Skills required are Arduino, Electrical Engineering, C Programming, Electronics, Microcontroller