Heat conduction problem in hollow cylinder, engineering, Other Engineering

Assignment Help:
Heat conduction problem in hollow cylinder
There are a lot of researches for calculating the temperature field in various shapes using different boundary and initial conditions. Some researchers have used analytical approaches to solve the periodic heat conduction problems. In 1947,Hesser obtained unstable temperature field in a long solid cylinder, solid sphere and infinite flat plate, with homogeneous boundary condition. Also, Ozisik(1993) determined the unstable temperature field in solid cylinder under the periodic boundary condition. Trosel(1956) gained stresses field created by different temperature distribution.VDI(2003) presented the calculation of periodic boundary condition which is simulated by harmonic oscillation of ambient temperature.
Earlier work in this field focused on one-dimensional heat conduction in solid and hollow cylinders. Carslaw and Jaeger(1957) discussed the general heat conduction problem with emphasis on solid cylinders. Analytical solutions to unsteady heat conduction problems relied on the use of Green’s function but still proved extremely difficult.
The determination of temperature distribution in a medium (solid, liquid, gas or combination of phases) is the main objective of a conduction analysis, that is, to know the temperature in the medium as a function of space at steady state and as a function of time during the transient state. Once this temperature distribution is known, the heat flux at any point within the medium, or on its surface, may be computed from Fourier’s law.

Related Discussions:- Heat conduction problem in hollow cylinder, engineering

Which scheme provides the best spectrum capacity, Question: (a) What a...

Question: (a) What are the criteria that a frequency planner and a network engineer need to consider during cellular planning and design. (b) Assuming that you work as a c

The brayton cycle-aeronautical engineering, The brayton cycle: The work...

The brayton cycle: The working cycle of the gas turbine engine is similar to that of the four-stroke piston engine.  There is induction, compression, ignition and exhaust in bo

Mode iii interlaminar fracture toughness , Mode III Interlaminar Fracture T...

Mode III Interlaminar Fracture Toughness  The Mode III interlaminar fracture toughness of a composite can be measured using the split cantilever beam (SCB) geometry. Here, a c

Materials in design, I have assignments to due and I''m wondering if you co...

I have assignments to due and I''m wondering if you could do it for me

Where do you think by djia?, Where do you think by DJIA? Nobody knows th...

Where do you think by DJIA? Nobody knows the respond to this one. However, you should at least have some ideas on the topic and be able to communicate why you think this is the

Capital management solutions, Objective of corporate financing Corporat...

Objective of corporate financing Corporate finance control is a division of financial that refers to the control of money of an organization. The attention of corporate financi

Outcomes of the fra - fire protection engineering, Outcomes of the FRA: ...

Outcomes of the FRA: When interpreting the outcomes of the FRA, NFPA 551 states that there are two ways in which the situation can be assessed to determine if it is acceptable

Meer, write drawback of linear array

write drawback of linear array

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd