Heat and mass transfer, engineering, Other Engineering

Assignment Help:
1. Air at 1 atm, 90F, and 8 ft/s enters a thin-walled tube of 4-in diameter. The tube surface temperature is maintained at 60F. Air exits the tube at 70F. Determine the length of the tube required to accomplish this process. Work in English units!

2. A box 15-cm by 50-cm at a constant surface temperature of 35C is exposed to ambient air from all sides except the base (50cm by 50 cm in a horizontal plane). The ambient air is 1 atm, 25C. Estimate the natural convection heat loss from the top of the surface as well as the side surface

3. Air at 1 atm, 25C and 8 m/s is to be heated by an in-line tube-bank with 3 rows in the flow direction and 4 tubes in each row. The outside diameter of the tubes is 0.012m with a length of 0.2 m. The surface temperature of the tubes is maintained at 350 C. Taking the air properties at 35C, calculate:

a. The air temperature and heat transfer

b. The air pressure drop across the tube-bank


Related Discussions:- Heat and mass transfer, engineering

Fourier’s law of heat conduction, Fourier’s law of heat conduction For one ...

Fourier’s law of heat conduction For one dimension; q(x) = - k dT/dx (2.1) wher

Acoustic linings in aircraft engine, Acoustic linings in Aircraft engine: ...

Acoustic linings in Aircraft engine: One method of suppressing the noise from the fan stage of a high by-pass ratio engine is to incorporate a noise absorbent liner around the

Thrust indication - aircraft engine, Thrust indication: Although rpm ga...

Thrust indication: Although rpm gauges give an indication of the rotational speed of the compressor, they do have one drawback. They do not normally indicate the thrust output

Shrinkage cavities casting defects, Q.   Discuss briefly the causes and rem...

Q.   Discuss briefly the causes and remedies of Shrinkage cavities casting defects.                                                 OR  Why shrinkage cavities are caus

Electro-mechanical fuel control, Electro-mechanical fuel control: The s...

Electro-mechanical fuel control: The start fuel valve and ignition are energised as soon as rotation (3%) is sensed by an Electronic Sequence Unit (ESU). At 14% and with risin

What is Cash dividend , Cash dividend Companies mostly pay dividends in ...

Cash dividend Companies mostly pay dividends in cash. A company should have enough cash in its bank account when cash dividends are declared. If it does most have enough bank bal

Prepare a short document to sensitise public, Since the introduction of mob...

Since the introduction of mobile phones and other smart devices, concerns (both scientific and public) have been raised about the potential health impacts from regular use. Numerou

Oil filter debris analysis, Oil Filter Debris Analysis Oil filters serv...

Oil Filter Debris Analysis Oil filters serve an important function within the lubrication system of a gas turbine engine in that they remove foreign particles that collect in t

Inspecting a sprinkler systems, Inspecting a Sprinkler Systems: When i...

Inspecting a Sprinkler Systems: When inspecting a building that has sprinklers fitted it is not easy to check that the correct water pressure and flow rate can be achieved by

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd