form tool design, Mechanical Engineering

Assignment Help:
I want to make a form tool for lathe for making a convex groove of 3 mm radius. tool material will be tungsten carbide. I want to know the dimensions of tool. What is the procedure for deciding values of back rake angles and end clearance angle?

Related Discussions:- form tool design

Determine the location of the hydraulic jumps - water depths, Problem: In H...

Problem: In HEC-RAS, model this system as 1 reach with cross-sections every 2 ft. For all 3 discharges (labeled as: design, low, flood), (a) Determine the water depths 10 ft fro

Ratio of applied stress and yield stress, Ratio of applied stress and yield...

Ratio of applied stress and yield stress: What should be the ratio of applied stress, s, to yield stress s Y in a large thin plate so that plastic spread along lint of crack

Separator-battery components , Separator:   Separator works as insulator b...

Separator:   Separator works as insulator between positive and negative plates. These separators are placed between each pair of plates.

Calculate the angular acceleration of the wheel, Calculate the angular acce...

Calculate the angular acceleration of the wheel: A locomotive wheel of radius r = 0.8 m is illustrated in Figure. At the given instant, the speed of the locomotive is 1.6 m/se

State about the caisson foundations, Caisson foundations Caisson founda...

Caisson foundations Caisson foundations are similar to wells, but are much large in size. They are of different types, closed end, open ended and of pneumatic type. Figure show

What could be the characteristics of tool materials, (a) What could be the ...

(a) What could be the characteristics of tool materials. (b) Describe several tool materials with their composition.

Tributary lateral load, Tributary lateral load:   The question is on a f...

Tributary lateral load:   The question is on a fictitious 1965 building in Albany, NY. It was designed using the 1964 State Building Construction Code, in which Allowable Stress

Net angle of twist at the free end - steel shaft, Net angle of twist at the...

Net angle of twist at the free end - steel shaft:  The stepped steel shaft illustrated in Figure is subjected to a torque (T) at the free end and a torque (2T) in the opposite

Drum peel strength, what is the dimensions of drum peel strength testing fi...

what is the dimensions of drum peel strength testing fixtures

Design wellheads and wellpads, Q. Design Wellheads and Wellpads? Hydroc...

Q. Design Wellheads and Wellpads? Hydrocarbon-producing wellheads and wellpads shall be located in open, well ventilated areas with as much segregation from other critical equi

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd