Force system, Mechanical Engineering

Assignment Help:

Force system:

Define Non concurrent force system. Why we find the position of Resultant in Non concurrent force system?

Sol.: In Equilibrium of concurrent force system, all the forces are meeting at point of body. But if forces acting on body are not meeting at point, then the force system is called as Non concurrent force system.

In concurrent force system we find the resultant and direction of it. Because all the forces meet at one point so resultant will pass through that point which is the position of resultant is already clear. But in the non concurrent force system we find magnitude, distance and direction of resultant from any point of body as forces are not meet at the single point they act on many point of body, so we do not know the exact position of resultant. For finding out the position of resultant we used concept of moment.

 


Related Discussions:- Force system

#title.scale, actual division 2km is shown as 1 cm in a map.construct a cle...

actual division 2km is shown as 1 cm in a map.construct a clean scale to measure km which can travel a distance upto 30 km.Show measurement of 18 km in the scale

Benefits of registration in entrepreneurship development, Benefits of Regis...

Benefits of Registration: Units would normally get registered to avail some benefits, incentives or support given either by the Central or State Govt. The regime of incentives off

Find out the safe power transmitted by pulley, Find out the safe power tran...

Find out the safe power transmitted by pulley: A belt drives pulley of 200mm diameter such that ratio of tensions in tight side and slack side is 1.2. If maximum tension in b

Mockup test, we perform mockup test to 10 tube with tubesheet. please give ...

we perform mockup test to 10 tube with tubesheet. please give the cutting plan?

Determine the elongation of plate, Determine the elongation of plate: ...

Determine the elongation of plate: Q: A steel bar AB which is having uniform thickness 2 cm, tapers from 1.5 cm to 7.5 cm uniformly in a length of 50 cm. From 1 st principle

Maximum slope and maximum deflection, Maximum slope and maximum deflection:...

Maximum slope and maximum deflection: A simply supported beam of span l is subjected to two concentrated loads at one-third span through two supports. Discover the maximum slo

Manufacturing technology, Details of rolling process,Different rolling meth...

Details of rolling process,Different rolling methods,

What is transfer molding, Q. What is Transfer molding? Transfer molding...

Q. What is Transfer molding? Transfer molding was developed largely to avoid the disadvantages found which compression molding. • Transfer molding can make intricate or quit

Axis perpendicular to the vertical plane - square prism, Axis Perpendicular...

Axis Perpendicular to the Vertical Plane - square prism: Here a square prism, side of base 40 millimeter and axis 60 millimeter long is resting on the HP on its base along wit

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd